A4425gdta Parts

I had 2 parts that were cracked, so after changing the cracked parts as well as the dispenser switch, it was back to working normally. Simple to make the needed repairs and the videos provided on your website really helped in being prepared. Read more

I removed the drawers and old rails, and screwed in the new ones. It was very straightforward. Read more

I ordered the recommended front door shelf part Fz for my frig, it was shipped promptly. It was slightly too long, so I cut about a 1/4" with the saw... it fits nicely now. Read more

I had to disassemble the ice bucket, there were three screws to remove the cover, one screw and a tension spring that holds the bar in place that controls ice cubes from crushed ice. The hardest part was removing the plastic chamber where the ice crushing blades are attached to the auger, I had to use a couple of butter knives to spread the outer ice bucket away from the inner ice chamber because they had those funky plastic lock-in tabs that lock the ice chamber in place to the ice bucket. I... Read more

Replacing the roller assembly corrected the problem. The key to replacing the roller assembly is elevating the refrigerator high enough to remove the roller assembly. (1) Raise and secure the refrigerator, (2) remove the metal bar across the bottom of the refrigerator to provide adequate access to the roller assembly (2-screws), (3) remove the roller assembly adjustment screw, (4) pry the roller pivot pin out, (5) pull the roller assembly toward the front of the refrigerator to remove, (6)... Read more

At first, I thought the ice maker had gone bad. But then realized the frig side was getting warmer, so it was something bigger than just the ice maker. After doing some searching, i found this video, which was incredibly helpful. https://www.youtube.com/watch?v=EF14XHW9jWw In particular, the tip about checking continuity through the two connectors. The results sent me directly to the freezer's Defrost Thermostat and the Defrost Heater. Both were dead; the defrost bar glass was totally black,... Read more

I made the right initial move - I went to appliancepartspros.com and located the necessary parts. A video convinced me I could make the repairs myself. The correct parts were easily ordered and arrived quickly. I had no problem installing the parts using the knowledge I gained from the appliancepartspros.com video and the leak was fixed. Read more

Swapped it out for new tube. Take 5 minutes and zero effort. The drain tube will clog with mold. You can clean it out but the tube will clog again despite's you best efforts as the tube wall provide a great habitat. Ordered new tubes to facilitate swap-outs. Old tubes can be cleaned but will recolonize quickly. Read more

1) By using google to find videos on why the door wouldn't close, I found out I needed new cams, those same videos also showed how to remove and replace the door. 2) Then by googling the fridge model number and the word 'cam', I was able to find the parts. 3) Taking the door off was simple, I needed a phillips head screwdriver to remove the hinge cover, however the screws in the hinge plate were so tight, I needed a side handle socket wrench to loosen them. 4) The door itself is not hard to... Read more

It seems the ice maker is one of the luxuries I can't live without. I checked the water supply valve and everything seemed to work eight up to the ice maker. I ordered a replacement from Appliance Parts Pros. Installation took just a few minutes. Read more

Found the parts on this website and installed them. I was actually quite happy since there is a diagram of the door and I could go piece-by-piece to order what I needed. Read more