Ade3lrgs171tw01 Parts

This right-side end cap is a replacement trim piece that restores the finished appearance of the washer control/top edge and protects edges from wear. It matches the original shape and color for a clean factory look. What it does:

• Covers and protects the right edge/end of the control/top trim to prevent exposed edges
• Restores appearance when the original cap is cracked, broken or missing
• Helps keep the trim secured and reduces the chance of snagging or catching
• Matches factory color and fit for a seamless replacement

• Disconnect power to the appliance before beginning any repair.
• Remove the affected trim or panel per the service manual to access the end cap.
• The cap typically snaps or slides into place; use a plastic pry tool to avoid damaging surrounding trim.

This is a tapping screw with a hex head and Torx drive designed to fasten panels and components on Speed Queen laundry appliances. It provides a secure, vibration-resistant hold for repeatable service and repairs. What it does

• Fastens outer panels, brackets and internal parts where a self-tapping screw is required
• Holds components tight to prevent rattling or misalignment during operation
• Replaces missing, worn or stripped screws that cause loose or insecure parts
• Used when a screw must tap its own threads in sheet metal or thin substrates

• One tapping screw (hex head Torx)

• Use the correct Torx driver bit to avoid stripping the drive recess
• Drive straight and steady; do not over-torque to prevent thread or sheet-metal damage
• Follow OEM service instructions for panel removal and fastening order
• Disconnect power and follow safety precautions before servicing the appliance

A replacement low-profile Phillips screw used to secure panels and components on compatible laundry equipment. Provides a secure, low-profile fastening where a shorter head is required. What it does:

• Fastens trim, control panels, or small brackets where a low-profile head is needed
• Restores secure attachment when original screws are missing or stripped
• Helps eliminate rattling or loose panels caused by missing hardware
• Matches common #8 AB-18 x 1/2" thread and length for specified OEM fittings

• Use the correct Phillips screwdriver to avoid cam-out and head damage
• Start threading by hand to avoid cross-threading; do not force
• Tighten until snug—do not over-torque to prevent stripping the mating threads
• If threads are damaged, replace with an appropriate fastener or repair the hole before installing

This is a 8-AB-16 x 3/4 Phillips truss-head screw used to fasten appliance panels and components. It provides a low-profile, wide bearing surface to hold trim, guards, and light assemblies securely. What it does:

• Fastens panels, trim pieces, brackets and lightweight assemblies
• Wide truss head distributes load to prevent surface damage
• Phillips drive for common screwdriver or bit compatibility
• Helps stop rattling or loose panels when a worn or missing screw is replaced

• Use the correct #2 Phillips driver to avoid stripping the head
• Thread into original hole; do not force if threads feel damaged
• Tighten snugly but avoid overtightening to prevent stripping or cracking surrounding material
• Keep removed hardware organized for reassembly; replace any damaged mating parts

This left-side cabinet panel restores the exterior side of the washer/dryer cabinet for a clean, finished appearance and cabinet stability. It replaces a dented, rusted, or damaged side panel to improve looks and protect internal components. What it does:

• Replaces a damaged or corroded left cabinet side to restore cabinet strength and appearance
• Covers and protects internal components from dust and accidental contact
• Helps prevent moisture and debris from reaching internal parts that can cause wear
• Returns the cabinet to a flush, finished profile for proper enclosure fit

• One left cabinet side panel (single piece, as shown)

• Disconnect power and water before starting work
• Remove adjacent panels or trim as needed to access mounting screws; keep hardware for re-use unless damaged
• Handle edges carefully—wear gloves to avoid cuts and alignment damage
• Test fit and align before tightening fasteners to ensure proper panel gaps and secure fit