Ade8060 Parts

12-pack mounting screws for various appliances. Replaces missing, stripped, or damaged screws used to secure panels, brackets, and components.

This female piggyback terminal is a quick-disconnect electrical connector designed to join or extend wire connections safely, letting a second male tab piggyback on an existing spade connection for easy component hookups. What it does:

• Provides a secure female quick-disconnect that accepts a male spade and allows a second male tab to be connected on top (piggyback).
• Used where an additional circuit or component needs to tap into an existing spade connection.
• Commonly replaces worn, corroded, or loose spade/terminal connections that cause intermittent power or component failure.
• Helps restore reliable electrical contact and reduces arcing from poor terminals.

• Disconnect power to the appliance before inspecting or replacing terminals to avoid shock or damage.
• Crimp or solder per OEM guidance and use appropriate insulation or heat-shrink if required.
• Replace damaged wiring or terminals; secure harnesses to prevent strain on the new connector.

This right-side end cap is a replacement trim piece that restores the finished appearance of the washer control/top edge and protects edges from wear. It matches the original shape and color for a clean factory look. What it does:

• Covers and protects the right edge/end of the control/top trim to prevent exposed edges
• Restores appearance when the original cap is cracked, broken or missing
• Helps keep the trim secured and reduces the chance of snagging or catching
• Matches factory color and fit for a seamless replacement

• Disconnect power to the appliance before beginning any repair.
• Remove the affected trim or panel per the service manual to access the end cap.
• The cap typically snaps or slides into place; use a plastic pry tool to avoid damaging surrounding trim.

This push-in plug button is a small replacement cap that covers and seals an unused opening or socket on compatible appliances, keeping the area clean and helping prevent debris and moisture entry. What it does:

• Covers an unused plug hole or access port to block dust, dirt, and moisture.
• Provides a finished appearance by hiding raw openings in panels or control housings.
• Helps keep internal components protected from contaminants that can affect operation.
• Snaps into place for a secure fit without adhesives.

• Disconnect power to the appliance before accessing panels or openings.
• Typically installs by pressing into the opening until it snaps flush; no special tools required.
• Verify correct fit and orientation before final reassembly.
• If panel damage is present or the button does not seat securely, inspect mating opening or surrounding clips.

Backguard shield cap for dryers. Covers and protects the rear panel components. Replace if cracked, broken, or missing to restore proper appearance.