Adg3lrs111tw01 Parts

This Outer Tub Gasket seals the outer tub assembly in your washer to keep wash water contained through every cycle. Replacing a flattened, cracked, or leaking gasket helps stop water on the floor and protects internal parts.

• Creates a watertight seal between outer tub components
• Helps prevent leaks during fill, wash, and spin
• Common symptoms: water under the washer; moisture at the tub seam; visible cracks or compression set on the gasket
• Restores proper sealing after service or disassembly

• Disconnect power and water supplies; move the washer for safe access
• Access the outer-tub seam per your model's service procedure; note gasket orientation
• Remove the old gasket and clean mating surfaces; install the new gasket evenly without twists or gaps
• Reassemble and run a brief test cycle to check for leaks

This is a 8-16 x 5/8 tapping screw with a #6 Phillips drive, used to fasten panels and components on compatible appliances. It provides a secure, low-profile hold for trim, brackets and covers. What it does:

• Secures panels, trim pieces, brackets or small components to the appliance frame
• Replaces missing or damaged screws that cause loose or rattling parts
• Helps maintain proper alignment and fit of exterior or interior panels
• Provides a threaded connection in sheet metal or tapped holes

• Use the correct #6 Phillips screwdriver or bit to avoid stripping the head
• Start threading by hand to ensure alignment, then tighten until snug — do not overtighten
• Replace stripped or damaged screws to ensure secure fastening
• Wear eye protection and disconnect power to the appliance before working on components

This orifice is the calibrated gas jet that meters natural gas flow to the burner for proper combustion in compatible dryers. It helps maintain consistent heat output and stable burner operation when installed correctly. What it does:

• Controls the amount of natural gas delivered to the burner for stable flame and drying performance
• Replaces a worn, damaged, or incorrectly sized orifice that can cause weak flame or inconsistent heat
• Helps prevent flame irregularities and cycling issues caused by improper gas metering
• Used where a #45 natural gas orifice specification is required by the appliance

• Turn off gas supply and electrical power before servicing; follow all safety and local code requirements
• Install only if the #45 NG size is specified for your appliance; do not file or enlarge the orifice
• Inspect fittings and seat for debris; ensure a tight, leak-free connection using approved sealants or gaskets