Agr5844vdb Parts

This surface burner orifice holder is intended for use with gas ranges. This piece supplies gas to the burner. It also has a spark igniter electrode, so when the burner is turned on it will light. If there are problems with this piece, the gas will not get to the burner, and there could be a leak that may become dangerous. When there are issues, this part should be replaced immediately.This surface burner orifice holder is made from metal and should last a long time. However, there is a chance that it could become damaged or corroded over time or because of an accident with the range. The owner should always make sure to turn off the gas before working on the range, including the burner orifice holder.This surface burner orifice holder is compatible with many models of ranges from Maytag, Amana, Estate, and Whirlpool. This is a genuine OEM replacement part that has been sourced directly from the manufacturer. The holder is sold individually.

Secures panels, brackets, and trim pieces on ranges and cooktops. Replace if stripped, corroded, or missing to eliminate rattles and looseness.

This is a genuine replacement screw used to fasten panels, trim, and small appliance components. Replacing a damaged or missing screw restores secure mounting and reduces vibration or rattling. What it does:

• Secures panels, brackets, or trim pieces to appliance frames or assemblies
• Prevents loose parts that can vibrate, rattle, or misalign controls
• Replaces stripped, corroded, or lost screws to restore proper fit
• Small hardware solution for routine repairs and maintenance

• Use the matching screw hole and thread carefully to avoid cross-threading
• Hand-start the screw, then tighten with the correct driver until snug; do not over-tighten
• Disconnect power and follow appliance safety procedures before accessing internal parts
• Apply penetrating oil and proceed gently if the original screw is corroded or seized

Replacement mounting screw for ranges. Secures panels, trim pieces, control boards, and brackets. Order when original screws are missing, stripped, or damaged.

Replace a worn, cracked, or missing range control knob. Fits onto the control shaft to restore a secure grip for reliable temperature settings.

Black left side end cap panel for electric and gas ranges. Replaces cracked, broken, or damaged side trim pieces. Installs on left exterior edge.

Mounting bracket secures range components to the cabinet or chassis. Replace if cracked, broken, or missing to restore proper panel alignment and stability.

Screw for gas ranges and ovens. Used to secure panels, brackets, or internal components. Replace if lost, stripped, or corroded during repairs.

This small metal clip secures the body side panel to the range frame. It snaps into place to hold panels firmly aligned and prevent rattling or looseness. Replace this clip if your side panel feels loose, shifts out of position, or if the original clip has broken or gone missing during a repair.

Lower heat shield for gas ranges. Protects internal components from excessive heat. Replace if cracked, warped, or damaged to maintain proper insulation.

Metal heat shield that protects range components from direct heat damage. Installs near oven cavity. Replace when original is warped, cracked, or missing.

Manifold pipe for gas ranges. Connects gas supply to burner valves. Replace if cracked, corroded, or leaking. Essential structural component.

This orifice holder secures the burner tube and gas orifice for the left rear surface burner rated at 9,500 BTU. It ensures proper gas flow and alignment between the orifice and the burner head for correct flame distribution. Replace this part if you notice uneven flames, difficulty igniting the burner, or if the holder is cracked or corroded.