Ats9169as Parts

This drier is the factory replacement air/gas flow assembly that helps maintain proper airflow and drying performance in compatible laundry dryers. Replacing a worn drier restores consistent drying and reduces overheating risk. What it does:

• Directs and stabilizes heated air through the drum for efficient drying
• Helps prevent restricted airflow that can cause long dry times or damp laundry
• Supports safe exhaust flow to reduce the chance of overheating or lint buildup
• Works with the dryer's heating and ventilation components to maintain normal operation

• One drier assembly as shown

• Disconnect electrical power before beginning service; if this is a gas dryer, turn off and disconnect the gas supply
• Follow the dryer manufacturer's service manual for disassembly and reassembly steps
• Use appropriate hand tools and avoid forcing parts; inspect venting and lint traps while replacing

A replacement self-tapping pan-head screw sized 10 x 5/8 in for securing appliance panels, trim and small assemblies. Restores proper fastening where original screws are missing, stripped or corroded. What it does

• Cuts its own mating thread in sheet metal or plastic for secure fastening
• Commonly used to attach control panels, trim pieces and small brackets
• Helps stop rattles, loose panels and misaligned trim when original fasteners fail
• Corrosion-resistant finish resists rust in typical laundry appliance environments

• Use the correctly sized screwdriver or driver bit to avoid stripping the head
• Start in a pilot hole if material is brittle or if reinstalling into worn threads
• Do not over-torque; stop when the head seats flush to avoid cracking or stripping
• Disconnect power and follow appliance-specific safety procedures before working

This front dispenser drawer replaces a cracked, broken, or worn detergent/bleach drawer so detergent dispenses cleanly and the washer front looks finished. It restores the dispenser opening and provides a proper seal for product delivery. What it does:

• Replaces the front-facing detergent/bleach dispenser drawer assembly
• Keeps detergent and additives contained for proper dispensing during cycles
• Prevents leaks and drips from a damaged or cracked drawer face
• Improves fit and appearance of the washer's dispenser area

• Disconnect power and follow the washer manufacturer's safety instructions before servicing
• Remove the old drawer by pulling out and releasing any retaining clips; install the new drawer by aligning and snapping into place
• Check for proper seating and smooth operation before returning the washer to service

This hex washer-head screw secures panels and components in commercial washers and dryers, providing a low-profile, vibration-resistant fastener that helps keep assemblies tight and aligned during operation. What it does:

• Fastens sheet metal and plastic parts where a wide bearing surface is needed
• Hex washer head spreads load to reduce pull-through on soft materials
• Self-tapping thread cuts into mating material for a secure fit without a nut
• Commonly used where vibration and repeated motion can loosen standard screws

• Use the correct size driver or socket to avoid stripping the head
• Start the screw straight and apply steady pressure while driving to ensure proper thread engagement
• Tighten until snug — avoid over-torquing which can strip threads or crack panels
• Disconnect power and follow all safety precautions before servicing appliance

This hex head machine screw fastens appliance panels and components, restoring secure assembly and stopping movement or vibration. It's a simple replacement when original screws are lost or worn. What it does:

• Secures panels, brackets, and internal components to prevent rattling or misalignment
• Replaces missing or damaged screw heads that keep parts firmly attached
• Restores proper fit where stripped or corroded fasteners allow play
• Helps maintain safe operation by keeping covers and guards in place

• Disconnect power and water before working on the appliance
• Use the matching hex driver or socket to avoid rounding the head
• Replace like-for-like; tighten until snug but avoid over-torquing
• If threads are damaged, inspect mating part and replace as needed