Awn432sp113 Parts

Fix a washer that won't advance cycles or drain properly. This timer controls wash sequences and cycle progression. Common DIY repair for stuck cycles.

Softener not dispensing or leaking? This washer dispenser assembly holds and releases fabric softener during rinse. Fixes clogs and cracks.

The Aluminum Pulley Kit is an OEM component specifically designed for Speed Queen commercial washers. This kit includes both an aluminum pulley and the necessary shaft and hardware for proper installation. 

The pulley works with the washer's transmission system to transfer rotational power to the internal drum and cabinet components. It allows for controlled, consistent movements throughout wash and spin cycles.

Symptoms of a bad pulley kit include: 

• Excessive vibration and noise during operation
• The washer fails to advance through cycles properly  
• Damage to belts or other transmission parts

Causes of pulley failure can be wear over time, cracks or warping of the aluminum from overheating, or damage from dropped loads that impact the pulley area.

This OEM Speed Queen replacement part is also compatible with Dexter, Huebsch, Milnor, and IPSO commercial washer models.
 

Seals the joint between wash tub and tub cover to prevent water leaks during agitation and spin. Replace when you notice rim leaks or water escaping.

Cosmetic bezel ring that mounts behind the timer knob on your washer control panel. Replace if cracked, broken, or missing to secure the knob properly.

Right-side lid hinge that supports and pivots the washer lid. Replace if your hinge is worn, bent, cracked, or causing misalignment of the lid.

Left-stop lid hinge for top-load washers. Supports and pivots the lid on the left side while limiting opening travel. Replace if bent or worn.

If water splashes excessively during fill or leaks near the inlet, a cracked inlet deflector may be the cause. This part directs water properly.

10 oz sealant cartridge forms a flexible, watertight seal around washer tubs, door boots, and panel seams. Replace when repairing leaks or resealing.

Fix leaks or weak water flow during fill cycles with this washer water inlet hose. Connects the valve to the inlet fitting. Direct-fit replacement.

Extension kit adds length to your washer's drain hose when it doesn't reach the standpipe or sink. Includes coupling and gooseneck for secure hookup.

Replacement screw for washers. Secures panels, brackets, and internal components. Needed when original hardware is missing, stripped, or corroded.

Replaces missing or damaged 10B-16 x 0.34 inch cabinet screw. Secures panels, brackets, and covers. Restores tight fit to reduce vibration and rattles.

This left-side white panel end replaces a damaged or worn corner trim on the control console or front fascia to restore appearance and protect edges. Designed to match original fit and finish on compatible Speed Queen units. What it does:

• Covers and protects the left edge of the console/front panel from bumps, wear, and moisture.
• Restores a clean, finished look when the original panel end is cracked, chipped, or missing.
• Helps maintain proper alignment and support for adjacent trim and fasteners.
• Fits in place of the factory left-side panel end for straightforward cosmetic repair.

• Designed for direct replacement; reinstall using original screws/clips when present.
• Inspect adjacent trim and fasteners; replace any damaged clips to ensure secure fit.
• Power down and unplug the appliance before attempting any repairs that require panel removal.

Fix washer water leaks with this inlet valve hose. Simple repair—turn off water, remove front cover (4 screws), and replace. Takes under 30 minutes.

Secures the washer lid hinge to limit travel and maintain smooth operation. Replace this clip if worn, broken, or missing to restore proper lid alignment.