Awne82sp113tw01 Parts

If water splashes excessively during fill or leaks near the inlet, a cracked inlet deflector may be the cause. This part directs water properly.

10 oz sealant cartridge forms a flexible, watertight seal around washer tubs, door boots, and panel seams. Replace when repairing leaks or resealing.

Extension kit adds length to your washer's drain hose when it doesn't reach the standpipe or sink. Includes coupling and gooseneck for secure hookup.

Fix leaks or weak water flow during fill cycles with this washer water inlet hose. Connects the valve to the inlet fitting. Direct-fit replacement.

If your washer won't drain or leaves standing water, the drain hose may be kinked, clogged, or cracked. This part channels water out after each cycle.

Replaces missing or damaged 10B-16 x 0.34 inch cabinet screw. Secures panels, brackets, and covers. Restores tight fit to reduce vibration and rattles.

If your washer won't start cycles, stops mid-cycle, or the drive motor doesn't run, this control assembly restores timed wash and spin cycle operation.

This left-side white panel end replaces a damaged or worn corner trim on the control console or front fascia to restore appearance and protect edges. Designed to match original fit and finish on compatible Speed Queen units. What it does:

• Covers and protects the left edge of the console/front panel from bumps, wear, and moisture.
• Restores a clean, finished look when the original panel end is cracked, chipped, or missing.
• Helps maintain proper alignment and support for adjacent trim and fasteners.
• Fits in place of the factory left-side panel end for straightforward cosmetic repair.

• Designed for direct replacement; reinstall using original screws/clips when present.
• Inspect adjacent trim and fasteners; replace any damaged clips to ensure secure fit.
• Power down and unplug the appliance before attempting any repairs that require panel removal.

Stainless steel Torx screw secures panels, console trim, and internal brackets on laundry centers and washers. Replace when missing or stripped.

Fix a washer that won't start, won't spin, or shows error codes with this output board control assembly. Controls electronic signals to key components.

Fix leaks or water flow issues in your washer with this PVC water tubing. Replaces cracked, kinked, or blocked tubing directing water through the system.

A replacement cord lead-in that routes incoming power into the appliance and provides a secure connection point for the main wiring. Restores reliable electrical feed and helps eliminate intermittent power or no-power issues. What it does:

• Transfers household power from the external cord to the appliance's internal wiring
• Provides a stable inlet connection and strain relief for the incoming power cable
• Commonly replaced for symptoms such as no power, intermittent power, blown fuses, or visible damage/corrosion at the inlet
• Matches OEM fit and mounting for a direct replacement when the part number is correct

• One cord lead-in assembly

• Disconnect all power at the breaker or unplug the appliance before starting work
• Route wires and secure strain relief per OEM guidance; tighten terminal connections firmly but do not overtighten
• If wiring or terminal damage is present, replace or repair per local electrical code

If your washer isn't draining completely or leaking from the bottom, the tub to pump hose may be clogged or cracked. This hose drains water from tub to pump.

Secures the washer's tray or lid trim to prevent rattling and unwanted movement. Replace if cracked, broken, or missing to restore a snug fit.

If your washer overfills or underfills, the water level pressure switch likely needs replacement. This switch detects fill height and signals the control.

Fix washer water leaks with this inlet valve hose. Simple repair—turn off water, remove front cover (4 screws), and replace. Takes under 30 minutes.