B22cs30sns/1 Parts

Reinforces and secures refrigerator components to reduce movement and maintain alignment. Replaces broken, cracked, or missing brackets that cause loose or rattling parts.

If your refrigerator isn't dispensing water or ice maker won't fill, the water inlet valve may be faulty. Controls water flow to dispenser and ice maker.

Fix a refrigerator that won't respond to temperature controls or runs constantly with this electronic control board. Restores normal operation and cycle management.

This drain gutter is the molded channel that collects and directs wash water toward the dishwasher drain, helping prevent pooling at the tub base and under the door. It restores proper water flow inside the lower tub area. What it does:

• Channels leftover wash and condensation to the pump/drain to avoid water buildup under the door
• Helps reduce leaks and water pooling at the bottom front of the tub
• Replaces cracked or warped gutters that cause misdirected drainage or visible water inside the door area
• Matches OEM shape so water follows the intended path to the drain system

• One drain gutter

• Disconnect power to the appliance before beginning any repair
• Remove the dishwasher door or lower access panel per the service instructions to reach the gutter
• Handle carefully to avoid damage to the molded edges and to prevent contact with sharp cabinet or panel edges
• Secure mounting so the gutter seats fully to the tub and mates properly with adjacent seals

The Motor is an OEM part for Bosch refrigerators. This motor is specifically designed to power the ice dispenser mechanism, allowing for the convenient dispensing of ice cubes or crushed ice. It delivers the necessary power to rotate the dispenser auger, providing you with a steady supply of ice whenever you need it.

A bad motor can occur due to wear and tear, electrical malfunctions, or motor failure. Signs of a faulty motor include the ice dispenser not working, the auger not rotating, or unusual grinding or buzzing noises during ice dispensing.

Symptoms of a bad motor include:

• Inability to dispense ice  
• Noisy or erratic operation 

Replace your malfunctioning or worn-out ice dispenser motor with this genuine OEM Bosch part to restore your refrigerator's ice dispenser. This Bosch part can also be used on Thermador and Gaggenau appliances.
 

Fix a refrigerator not cooling properly or freezing unevenly with a new evaporator coil. This part absorbs heat to keep your fridge cold. Moderate DIY.

Replacement holder for your refrigerator interior. Installs to secure components in place. Order now if your original holder is cracked, broken, or missing.

The adjusting screw allows you to level your refrigerator and adjust door alignment, typically located at the base of the unit. Replace when the screw becomes stripped, corroded, or can no longer properly support or adjust the refrigerator.

This door seal fits around the dishwasher tub opening to keep water and steam inside during cycles. Replacing a worn gasket restores a tight seal so the door latches properly and helps prevent leaks at the sides or bottom.

• Creates a watertight barrier between the door and tub during wash and rinse cycles
• Helps contain steam and reduce moisture escaping from the front of the unit
• Replaces a flattened, cracked, torn, or deformed seal that can cause leaks
• Common symptoms include drips at the front edge, water on the floor near the door, and needing extra force to latch

• Disconnect power and, if applicable, shut off the water supply before servicing
• Pull the old seal from the channel; clean the groove and mating surfaces thoroughly
• Press the new seal in evenly without stretching; seat corners fully and position the joint at the bottom center
• Close the door to help the seal set; a snug fit at first is normal

This is a flexible rubber seal that attaches around the perimeter of the freezer door, creating an airtight closure when the door is shut. It prevents warm air from entering the freezer compartment and keeps cold air from escaping. Replace this gasket if you notice frost buildup inside the freezer, the door does not seal tightly, the gasket is torn or warped, or the compressor runs more frequently than normal.

Replacement freezer storage tray for your refrigerator. Installs inside the freezer compartment to organize and store frozen items. Order now if cracked or broken.

This is an electrical on/off switch used to control power to an appliance circuit. It replaces a failed switch so controls respond normally and the appliance can be powered on and off safely. What it does

• Opens and closes an electrical circuit to enable or disable appliance power or a specific control function
• Commonly replaces a worn, stuck, or unresponsive switch that prevents controls or lights from operating
• Can resolve symptoms like no power to a control, intermittent operation, or a button that won't actuate
• Designed to mate with the appliance's existing wiring and mounting points

• One electrical on/off switch

• Disconnect power to the appliance at the breaker or unplug before working on wiring
• Verify proper wire locations and secure all terminal connections; replace only with the exact part specified by the manufacturer
• Handle the part carefully to avoid bending terminals or damaging the switch actuator

This door switch senses the dishwasher door position and tells the control when the door is closed so cycles can start or stop. It restores proper door sensing for reliable operation and safety. What it does:

• Detects when the door is fully closed so the control can begin or continue a wash cycle
• Prevents the dishwasher from starting or running when the door is open
• Common fix for symptoms like no-start, intermittent power to controls, or cycles that stop when the door moves
• Works with the latch/strike assembly to ensure a secure door closure signal

• One door switch

• Always disconnect power at the breaker or unplug the appliance before servicing
• Access typically requires removing the inner door panel; handle the inner door and glass carefully
• Verify wiring orientation and gently disconnect connectors; replace with identical wiring and secure all fasteners
• Test door operation before reassembling the door panels

If your refrigerator isn't cooling properly or cycles too frequently, the accumulator may need replacement. Protects the compressor from liquid refrigerant.

Fix poor cooling or warm spots with this refrigerator fan motor. Restores proper air circulation through cooling compartments. Moderate difficulty repair.