Bosch Hbl8750/Uc12 Parts

This replacement glass panel restores the visible door surface on compatible BOSCH appliances, helping repair cracks, chips, or scratches and returning the door to proper cosmetic condition. Use to replace broken or damaged door glass. What it does:

• Serves as the exterior/interior glass surface of the appliance door
• Replaces cracked, chipped, scratched, or otherwise damaged door glass
• Restores the door's appearance and supports proper door assembly fit
• Helps prevent direct exposure of internal components that damaged glass might allow

• Turn off power to the appliance and disconnect power before beginning service
• Handle the glass carefully; wear cut-resistant gloves and eye protection
• Door disassembly is commonly required — follow the manufacturer's service manual
• Do not use if shipping damage is evident; contact seller before installation

This trim plate is a decorative front trim piece that restores the finished appearance of your appliance and covers the seam between control panels or door edges. It helps keep edges sealed and improves overall aesthetics. What it does:

• Provides a finished, factory look by covering exposed gaps or seams
• Protects underlying edges from dust, dirt and light impacts
• Helps maintain alignment and appearance around the control/door area
• Commonly replaced when the original trim is scratched, dented or warped

• Disconnect power to the appliance before starting any work.
• Installation typically requires removing adjacent trim or screws; keep fasteners for reuse.
• Handle painted or chrome finishes carefully to avoid scratches; use gloves if available.

This is a replacement nut used to secure internal appliance components. It restores proper fastening so assemblies stay tight and reduces noise or movement caused by loose hardware. What it does:

• Secures brackets, trim or internal components to prevent parts from shifting
• Stops rattling or vibration caused by a missing or loose nut
• Restores proper fastening after maintenance or repair
• Helps maintain correct alignment of the secured component

• Disconnect power and water before accessing internal parts
• Use appropriate hand tools and a firm grip; avoid power tools that can over-torque
• Do not overtighten — snug until secure to avoid stripping threads
• Replace any corroded or damaged mating hardware for a lasting repair

This cable harness connects key electrical components to restore power and signal flow in the appliance. It replaces a damaged or faulty wiring harness to help return controls and components to normal operation. What it does:

• Carries power and control signals between the control board and components
• Replaces frayed, burned, or broken wires that cause intermittent or no operation
• Common symptoms it can address: appliance won't start, controls unresponsive, intermittent cycles, or error codes related to open/shorted circuits
• Helps ensure secure connector mating and correct signal routing when installed properly

• Disconnect power at the breaker or unplug the appliance before starting any repairs
• Compare the new harness to the old one and follow the appliance wiring diagram for correct routing and connector placement
• Secure connectors fully; avoid sharp bends or pinching the wires during reassembly

This microswitch is a small snap-action switch used to detect position and complete control circuits in appliances, restoring reliable on/off or closed/open signaling for door and actuator mechanisms. What it does:

• Acts as a position/limit switch to detect door or actuator positions and send the signal to the control board.
• Restores proper control-circuit continuity so cycles can start or finish when the door or part is in the correct position.
• Common symptom: appliance won't start, stops mid-cycle, or shows a door/lock fault when the switch fails.
• Small, mechanical switching action — responds to an actuator or lever movement.

• One microswitch.

• Disconnect power before accessing or replacing the switch to avoid shock or damage.
• Verify the exact switch location and actuator orientation before removal; note wiring placement or take a photo for reassembly.
• Test continuity with a multimeter only after safely isolating the appliance; replace if it fails to open/close reliably.
• May require partial disassembly of the control panel, door latch, or actuator housing; follow appliance-specific service instructions.