Cgs985 Parts

Structural bracket that secures and supports the range door assembly. Replace if bracket is bent, broken, or damaged causing door misalignment or instability.

This rubber grommet cushions and seals a panel opening to protect wires, hoses or tubing from chafing and vibration. It helps prevent wear and keeps wiring routed cleanly through metal or plastic panels. What it does:

• Provides a protective, vibration-dampening barrier where wiring or tubing passes through a hole
• Helps stop chafing that can cause exposed insulation or hose damage
• Reduces noise from vibration where parts contact a cabinet or chassis
• Keeps the opening sealed against debris and light moisture intrusion

• One rubber grommet as shown

• Disconnect power and water before accessing panels
• Inspect the opening and mating surfaces; remove rust or sharp edges before installing
• Press grommet into the hole until fully seated; ensure wiring or tubing is routed without pinching
• Replace grommet if torn, hardened, or deformed; use only the specified size for a secure fit

This door bracket is the OEM mounting bracket that supports and secures a refrigerator/freezer door assembly, restoring proper door alignment and operation. It's a direct-fit replacement when a damaged or worn bracket prevents the door from closing correctly. What it does:

• Provides structural support for the door hinge area to keep the door aligned and stable
• Restores smooth opening and closing when a broken or bent bracket causes sagging or misalignment
• Helps maintain a proper door seal by returning the door to its correct position
• Prevents further wear to hinge components by replacing a compromised bracket

• Designed as a direct replacement; inspect adjacent hinge hardware and fasteners during installation
• Use appropriate hand tools; avoid overtightening fasteners which can strip threads or deform the bracket
• Disconnect power only if removal requires access near electrical components; otherwise power disconnection is not typically required

Fix uneven heating or gas flow issues with this range manifold pipe assembly. Distributes gas evenly to burners. Moderate difficulty repair.

Fix uneven burner flames or gas flow issues with this range manifold pipe assembly. Distributes gas evenly to cooktop burners for consistent heating.

Mounting bracket secures oven components inside your range. Replace if bracket is bent, cracked, broken, or missing to restore proper structural support.

This vent gasket seals the oven vent opening to help direct heat and exhaust properly while protecting surrounding cabinet surfaces. Replacing a worn or damaged gasket restores a tighter seal and reduces heat loss and odors. What it does:

• Seals the oven vent to help control heat and exhaust flow from the oven cavity
• Helps prevent excess heat from contacting adjacent cabinetry and controls
• Reduces drafts and heat loss that can affect cooking performance
• Can reduce burning or musty smells caused by trapped grease or damaged gasket material

• Disconnect power (or unplug) and allow the appliance to cool completely before starting
• Remove any trim or screws securing the old gasket; replace with the new gasket and secure per service manual
• Inspect mating surfaces and clean away grease or debris before installing for a proper seal