Cs2985set3ss Parts

Front grille kickplate panel for refrigerators. Covers the base area below the doors. Replace if cracked, broken, discolored, or missing.

This clamp secures flexible hoses to fittings to maintain a tight seal and prevent leaks. Use it to replace a worn or loose clamp to stop water or air seepage and restore proper hose attachment. What it does:

• Holds a washer, dryer, or appliance hose firmly to a barb or fitting to prevent slipping
• Helps maintain a watertight or airtight connection to reduce leaks and drips
• Replaces corroded, cracked, or stretched clamps that no longer grip reliably
• Supports normal appliance operation by keeping fluid/air flow contained

• One clamp

• Inspect the hose and fitting; replace the hose if damaged before installing the clamp
• Position clamp over the hose barb and tighten evenly; avoid over-tightening that can cut the hose
• Disconnect power and water supply before servicing any appliance components

Secures the drain extension tube in your refrigerator's defrost system. Replace if clip is broken, cracked, or missing to properly hold drain tubing in place.

Water dispenser not working or runs continuously? This refrigerator dispenser switch controls water and ice flow. DIY repair in 15-30 minutes.

This trim piece attaches to the refrigerator door handle area, providing a finished appearance and helping secure the handle in place. It snaps or screws onto the door panel near the handle mounting points. Replace this trim if it is cracked, discolored, or broken, which can make the handle feel loose or detract from the door's appearance.

This thermal overload protector helps prevent motor overheating by interrupting power when temperatures exceed safe limits. It restores normal operation once the motor cools, protecting the appliance from damage and reducing risk of failure. What it does:

• Senses excessive motor temperature and interrupts current to stop the motor from running when overheated
• Helps prevent motor burnout and related electrical damage
• Can resolve symptoms such as a dryer or washer motor that stops mid-cycle, won't start, or trips the circuit during heavy use
• Works as a safety device in the motor circuit rather than a control or relay

• One thermal overload protector

• Disconnect power before accessing or replacing the motor overload; follow appliance-specific service manual steps
• Handle terminals and wiring carefully; replace using the same connections and orientation as the original
• If the motor repeatedly overheats after replacement, inspect motor bearings, venting, or other causes rather than replacing overload repeatedly

Refrigerator fan guard protects the evaporator or condenser fan from debris. Replace if cracked, broken, or missing to prevent fan damage. Verify fit by model number.

Replacement mounting screw for refrigerator interior components and panels. Needed when original screws are stripped, lost, or damaged during repair.

Mounting screw for refrigerator assembly and component installation. Replace missing, stripped, or damaged screws to secure panels, shelves, or hardware.

Secures the control box assembly in your refrigerator. Replace this clip if it's broken, cracked, or missing to properly mount the control housing.

Wiring harness that connects dispenser components in your refrigerator. Replace if wires are damaged, frayed, corroded, or connections are loose or broken.

Replacement shelf support track for refrigerators. Guides shelves to slide smoothly in and out. Replace if cracked, broken, or worn to restore alignment.

This is a replacement mounting screw used to secure appliance panels and small components. It provides a correct-fit fastener to restore secure attachment and eliminate rattles or loose parts. What it does:

• Secures trim, panels, brackets, or small assemblies to prevent movement and vibration
• Restores proper alignment when a worn or missing screw causes loose parts or noise
• Works as a direct-replacement fastener where the OEM screw specification is required

• One replacement screw

• Use the correct driver bit to avoid stripping the head; do not overtighten
• Disconnect power and follow appliance safety guidelines when accessing internal components
• If the original mounting hole or threads are damaged, repair or replace the mounting hardware before reinstalling