Dg913 Parts

I had to replace the terminal block due to the 220 volt ark. A small fire at the bottom of the dryer caused the belt to partially burn. I had to replace it along with the 220 volt dryer cable. If the local hardware store would have taken the time to install the dryer with an additional 0.50 cent grommet, this could have been avoided. Thank you for sending the correct parts. This was the second time I had to use your service and I will continue to use it in the future. Read more

Be careful not to tighten or twist the small hex nut in the knob cylinder/housing with force. there is a very small plastic set tab that can be broken off easily. how do I know? The orientation of the switch "box" is horizontal instead of vertical. otherwise, this replacement part # works as expected. I couldn't get the switch to attach plate removed, and the switch removed, without removing the entire cooktop and removing the top glass burner cover. Not difficult, but time-consuming. Read more

Took the front panel off (the door front), disconnected the connector to the door switch and used a wooden clothespin to bypass the door switch. Turned on the dryer to locate loud squeaking sound and found it was coming from the motor area. When I started to take the blower section apart from the motor, that is when I saw the "blower wheel" slipped off the motor shaft. The blower wheel has a "C" clip retainer and compression ring to keep it snug on the motor shaft (but it was loose). Now I... Read more

Just opened up wire connections on all three (after taking pictures, since schematic was skewed) solenoid could and did a continuity check as one of them came back negative and just replaced it...all is working again. Read more

• No heat or not enough heat

This was a Maytag DE312 actually a Whirlpool labeled as Maytag) and is 27 years old. Replaced motor, drive belt and drum rollers. One tricky part was the motor because the new motor comes with integral starter and it was necessary to cut off existing female spade connectors on some wires and crimp on new connectors. Instructions were adequate but need to be carefully followed and a decent electrical stripping and crimping tool must be at hand. I bought a new motor drive pulley because another... Read more