Need Help?
Call
Some parts shown may not be for your model. To see parts for your model only, select it from "Matching Model Numbers" list on the left.
Replaced new parts with the new one, swapping one wire at the time. Read more
Replaces a cracked, rusted, or disconnected exhaust duct that routes hot air from your dryer to the home vent. Restores proper airflow and venting.
Removed front of dryer and back access plate allowing me to see that the pipe just slipped over the blower. A small tab in the back cover was inserted inside the left side of the pipe and when I straightened the tab I could move the pipe to the right and then straight out. Replacement of the pipe was the reverse. The new pipe did not have a hole for the tab, so I bent the tab to its original position, and rested the pipe against the tab. The new pipe had a rear flange that kept it in place.... Read more
This motor plate is the stamped metal mounting plate that secures the motor assembly and keeps it aligned for smooth operation. It restores proper motor positioning and reduces vibration-caused noise or wear. What it does:
Replaces a worn, damaged, or misaligned dryer motor pulley. Guides the drive belt and transfers motor power to the drum for proper rotation.
Replaced belt, pulley with a 4 grove pulley. Pulley that was on there was a 3 grove pulley, Had to cut the old one off, Press on to shaft. Replaced rear drum bearing. Bearing was locked on with a snap ring. Access to it from a removable plate on the back side of dryer. Reset belt and idler puller by removing a long back plate on the bottom rear side of the dryer. None of this was shown in your Video. Read more
Front bracket and leveling screw assembly.
This dampening band absorbs vibrations and reduces noise during your washer's spin cycle by cushioning the tub movement. It connects between the tub and the washer cabinet to minimize shaking and rattling sounds. Replace this part if your washer vibrates excessively, makes loud banging noises during spin, or walks across the floor during operation.
The sensor rods harness is the wiring assembly that connects the moisture or temperature sensor rods in a dryer to the main control board, allowing the dryer to detect when clothes are dry. This electrical connection enables automatic drying cycles to shut off at the right time, saving energy and protecting fabrics. Replace this harness if your dryer runs too long, stops too early, or if auto-dry cycles are not working properly.
8 - 18 ab flt 5/8 sn wh
Found a crack in timer knob, where it slides over timer. Ordered new timer knob, pulled off old knob and slid on new knob. Works as new now. Read more
E-coat
Size: 14-10 a.
By continuing to use our site, you agree to our Terms of Usage and Privacy Policy. You can learn more about how we use cookies by reviewing our Privacy Policy.
We use cookies to optimize website functionality, analyze the performance, and provide personalized experience to you. Use the controls below to manage your privacy preferences.
Cross-Site Advertising
When enabled, we may use cookies and similar technologies to deliver personalized advertisements based on your browsing activity across different websites. Opting out will disable third-party advertising cookies on this site.
Analytics Sharing
When enabled, we may share anonymized browsing and usage data with third-party analytics providers to help us understand how visitors use our site. Opting out will prevent this data from being shared with third parties.