Dsf25kgtebg Parts

This evaporator block seal replaces the rubber gasket that seals the evaporator block assembly to the freezer cabinet, helping maintain proper airflow and prevent leakage. It restores a tight seal around the evaporator block for reliable cooling performance. What it does:

• Seals the evaporator block to the cabinet to prevent warm air intrusion and water leaks
• Helps direct refrigerant-condensed water into the drain rather than inside the cabinet
• Commonly used when you see frost build-up around the evaporator or water pooling in the freezer
• Helps maintain consistent cold temperatures by preserving the sealed evaporator area

• One evaporator block seal

• Designed for field replacement; inspect surrounding gaskets and mounting surfaces for damage before installing
• Clean and dry mating surfaces thoroughly to ensure a proper seal
• Use common hand tools; avoid over-stretching or cutting the seal during installation
• Disconnect power to the appliance before servicing and follow safety precautions for refrigeration components

This replacement corner cap restores the finished edge and protective cover on an oven door corner for a clean appearance and proper fit. It replaces a cracked, chipped, or missing corner that can catch debris or show damage. What it does:

• Covers and protects the outer corner of the oven door from chips and dents
• Helps maintain a smooth door edge so the door closes and seals properly
• Improves cosmetic appearance when the original corner is cracked or worn
• Reduces sharp or rough edges that can catch on clothing or cause minor cuts

• Turn off power to the appliance and allow the oven to cool before servicing
• Installation may require partially removing the oven door or trim; have basic hand tools ready
• Handle the door and trim carefully to avoid scratching finished surfaces

This main board enclosure houses and protects the appliance's electronic control board, keeping wiring and circuitry secure and organized for reliable operation. It helps prevent contact damage and contains the control components in one location. What it does:

• Covers and protects the main electronic control board from debris and accidental contact
• Keeps wiring routed and secured around the control area to reduce strain on connectors
• Helps maintain correct positioning of the control board for consistent electrical connections
• Useful when the original housing is cracked, missing mounting points, or allowing exposed circuitry

• Disconnect power to the appliance before beginning any work to avoid shock or damage
• Handle the control board and connectors gently; avoid touching circuit traces or components
• Keep track of any mounting screws and brackets removed during disassembly for reinstallation

This adhesive-backed foam sealing strip provides a simple replacement to seal small gaps and cushion contact points on appliance doors and panels, helping reduce drafts, moisture intrusion, and rattling. What it does:

• Seals small gaps around doors, panels or assemblies to help limit air and moisture transfer and reduce condensation
• Cushions surfaces to minimize vibration and rattling noises
• Helps improve temperature retention by closing unintended openings
• Commonly replaced when foam is torn, compressed, detached, or causing drafts

• Verify the mounting surface is clean, dry and free of grease or old adhesive before applying
• Measure and trim the strip to fit; peel back adhesive liner and press firmly along the full length
• Avoid stretching the foam during installation for best seal and adhesion
• If adhesion is poor, remove residue and consider using a manufacturer-approved adhesive

This wire actuator engages the refrigerator dispenser paddle to activate water or ice dispensing. It restores reliable mechanical actuation for responsive dispenser operation without replacing the entire dispenser assembly. What it does:

• Translates paddle movement into the dispenser switch action so water or ice starts when the paddle is pressed
• Helps correct a dispenser that doesn't activate when the paddle is pushed
• Replaces a bent, broken or worn actuator wire that can cause inconsistent dispensing
• Works with the dispenser lever and switch assembly to restore proper alignment and motion

• Includes: 1 wire actuator for dispenser

• Disconnect power (unplug or shut off breaker) and turn off the water supply before starting
• Remove dispenser trim/paddle to access and replace the actuator; avoid forcing plastic clips
• Verify alignment with the dispenser switch and paddle during reassembly to prevent binding