Du800318351 Parts

Bought the time and replaced it. Read more

Replaced the diaphragm in the pump ,and replaced the check valve ( The rubber flap in the check valve had deteriorated around edges so I replaced that as well.) I don't understand why you can't get the rubber flap. I guess they have you over a barrel with that. No fault to Appliance Parts Pros, its not out there that I could tell. Great prices and service. Dish washer works like new. THANKS! Read more

Ordered the new o-rings for the pump housing and main filter screen unit. Cleaned all water hardness and other debris out of all parts. Main filter and inside parts clogged with water hardness/limescale and other debris. The 3" wide round filter internal was completely clogged with debris and some of the filter holes we crystallized with water limescale. The pump was in good shape but all the filters and parts just needed to be cleaned. Some useful tips on this Magtag Jet Clean... Read more

Replaced the water injector and seal. Read more

Removed dishwasher to replace spray arm pine--I replaced washer on pipe, too, and would recommend doing this just on principal. Removing dishwasher requires disconnecting power, water, and drain line--tools will vary depending on connections. i replaced drain line because original install was not done correctly--hose too short--You could probably do just this w/o pulling unit. All parts arrived very quickly and fit correctly. Read more

I had no hope of separating the panel from the frame without damaging the frame since the two parts were rusted pretty badly and the screws holding the panel to the frame were completely beyond salvage. So I had to replace both the panel and the frame. I ended up removing the electrical/electronic connections, removing the panel/frame from the hinge and then replacing it with the new parts. Took about 90 minutes but the hardest part was removing other items from the rusting frame without... Read more

Removed 8 screws that retain inner door to outer door. Removed rinse aid dispenser nut and replaced O-ring around dispenser. Also, removed 2 screws that retain the latch assembly and replaced rubber grommet around latch lever that retains soap dispenser door. Read more

The foam was shot on the detergent cup lid. Hard as a rock. Causing caking problems, dribble down the inside wall of the door and leaving lumps of detergent. Cut the door in half wit aviation snips and pulled out the two halves. Discovered at this point that the spring had gone soft. Bought one ahead of time, so I was set. Put the spring on the left pin, put the spring pin in the door, slipped the door into place (open) and put the right pin in with pliers. Door snaps open now. Read more

I rolled the old bottom rack out and pushed the new one in. With the top rack, I used a flat head screw driver to pry off the stoppers for the rack, removed the old rack from the rails, put the new rack in and put the stoppers back on. Good as new and easy to do! Read more

Ordered a new part and put on dishwasher. Read more