Need Help?
Call or text
Some parts shown may not be for your model. To see parts for your model only, select it from "Matching Model Numbers" list on the left.
Comes with thermostat, drain impeller, and seal.
Dishwasher plastic heating element nut. Used to hold down the heating element.
This part replaced the bolt side of the housing which is the only side I needed to replace. It fit perfectly. The repair took less than 5 minutes. Read more
Color: Biscuit. Other colors: For white use WP9744143, for black use WP9744142.
Replaced the drain & wash impeller kit. Read more
Made by Whirlpool. 3/8 inch FPT inlet.
It was a water supply issue. Not enough water, so pump couldn't generate enough pressure to spin the blades, etc. There WAS water getting into the machine, just not enough. To confirm the diagnosis, I just poured some water from a kitchen pan into the machine, then it was enough to make everything work, blades spin, etc. I could see the water going into the machine when the inlet valve engaged (door open, but manually engaging the door interlock switch), but it wasn't much flow. It turns out... Read more
1. To fix the leaks from around the door, I replaced the upper and lower door seals. These were purchased in a separate transcation, so they are not the parts shown here. The upper door seal worked as intended, but the lower seal would not stay in place on the lower edge of the door during a wash. Therefore I cleaned the grease and detergent off the old seal, and installed using silicone sealer/adhesive. The plastic edge pieces for the lower seal were supplied with the kit, and they installed... Read more
Replaced the fill hose with the replacement hose after removing about 5 inches. Works great! Read more