Dwu 7802 Aam Parts

Replaced the pump housing (which has half of the seal) and the impeller (which has the other, more important half of the seal). It was easy and would have been easier if I took more photos during disassembly. FYI, take your photos before you take it apart, not after.... Read more

• Not cleaning dishes properly

Ordered the new o-rings for the pump housing and main filter screen unit. Cleaned all water hardness and other debris out of all parts. Main filter and inside parts clogged with water hardness/limescale and other debris. The 3" wide round filter internal was completely clogged with debris and some of the filter holes we crystallized with water limescale. The pump was in good shape but all the filters and parts just needed to be cleaned. Some useful tips on this Magtag Jet Clean... Read more

Ordered the new o-rings for the pump housing and main filter screen unit. Cleaned all water hardness and other debris out of all parts. Main filter and inside parts clogged with water hardness/limescale and other debris. The 3" wide round filter internal was completely clogged with debris and some of the filter holes we crystallized with water limescale. The pump was in good shape but all the filters and parts just needed to be cleaned. Some useful tips on this Magtag Jet Clean... Read more

Replaced the water injector and seal. Read more

Removed dishwasher to replace spray arm pine--I replaced washer on pipe, too, and would recommend doing this just on principal. Removing dishwasher requires disconnecting power, water, and drain line--tools will vary depending on connections. i replaced drain line because original install was not done correctly--hose too short--You could probably do just this w/o pulling unit. All parts arrived very quickly and fit correctly. Read more

My son fixed it. Problem was one of the spinner pieces had worked itself loose and jammed the large arm from freely spinning. Read more

Still not completed, have to order part #PS11747606. When I receive it, I only have to assemble parts Read more

1. Pull the function dial off (upper front right panel) 2. Open dishwasher door so it's horizontal. 3. unscrew the torx bit screws around the inside of the door 4. lift up to expose inside of door. 5. remove protective cover (press in from each end to release clips) 6. the timer unit will now be visible 7. unscrew unit from panel 8. unplug wiring clusters 9. to install new unit just do everything in reverse (plug and play) Read more

Removed 8 screws that retain inner door to outer door. Removed rinse aid dispenser nut and replaced O-ring around dispenser. Also, removed 2 screws that retain the latch assembly and replaced rubber grommet around latch lever that retains soap dispenser door. Read more

Lower spray bar had what looked like spaghettis blocking & protruding from holes on top. Upon further inspection found to be some type of fiber. Further, inspection revealed fiber came from rinse arm. Ordered a new spray bar from you, arrived in three days. Clean all including filters/spray bar put all back together ran like new. The time listed below includes troubleshooting and a little head-scratching. Read more

The foam was shot on the detergent cup lid. Hard as a rock. Causing caking problems, dribble down the inside wall of the door and leaving lumps of detergent. Cut the door in half wit aviation snips and pulled out the two halves. Discovered at this point that the spring had gone soft. Bought one ahead of time, so I was set. Put the spring on the left pin, put the spring pin in the door, slipped the door into place (open) and put the right pin in with pliers. Door snaps open now. Read more