Ed20pk Parts

Replaced evaporator fan. As stated on included paperwork, the terminals were on the opposite side from the original fan motor. I had to swap out and use the included longer harness. Even then, it was barely long enough. It was an easy fix, except for disconnecting the harness and for taking out the two mounting screws for the motor assembly. The 1/4" screw heads are 2 inches from the evaporator coils, so I couldn't use a driver. I had to use pliers since I didn't have a quarter inch open end... Read more

Removed door and replaced hinges Read more

I replaced the start relay and overload switch with the single part Overload/Relay part number AP3119971. Now it operates like new. Had no problem replacing part, just followed instructions. I was very pleased at a single part replacement for both, relay and overload. I was expecting just to replace the overload. This is much, mush better. It's been running for over a week with no problems, Read more

I checked on line for possible issues and it came back to the PTC relay overload assembly. I ordered one and verified with the technician if the instructions for wiring it up to an older model is addressed. He sent me a copy of the instructions and it covered everything. The part came in a about three days and I had it wired up in about 30 minutes with no issues. It's been running like a champ. Read more

First replaced start capacitor but that did not work, the start kit which has a relay and overload protector is what was needed. The relay is actually the only part that was bad I believe. After pulling the relay off the compressor you could shake it and it rattled, the new one did not. Really pretty easy and definitely cheaper than a service call. Read more