Ed25pw Parts

Replaced evaporator fan. As stated on included paperwork, the terminals were on the opposite side from the original fan motor. I had to swap out and use the included longer harness. Even then, it was barely long enough. It was an easy fix, except for disconnecting the harness and for taking out the two mounting screws for the motor assembly. The 1/4" screw heads are 2 inches from the evaporator coils, so I couldn't use a driver. I had to use pliers since I didn't have a quarter inch open end... Read more

Removed door and replaced hinges Read more

Replaced the limit switch. Read more

I replaced the start relay and overload switch with the single part Overload/Relay part number AP3119971. Now it operates like new. Had no problem replacing part, just followed instructions. I was very pleased at a single part replacement for both, relay and overload. I was expecting just to replace the overload. This is much, mush better. It's been running for over a week with no problems, Read more

The new overload/relay kit corrected the problem. The Panduit/zip-ties supplied in the replacement kit didn't fit where the illustration showed in the directions but smaller zip-ties connected together did fit and held the relay against the compressor just fine and the sealant had good squeeze-out. Read more

I checked on line for possible issues and it came back to the PTC relay overload assembly. I ordered one and verified with the technician if the instructions for wiring it up to an older model is addressed. He sent me a copy of the instructions and it covered everything. The part came in a about three days and I had it wired up in about 30 minutes with no issues. It's been running like a champ. Read more

Removed the old slide. Took a few minutes to find the part, but not difficult. When it arrived installed it in about three minutes. Put the drawer back. Read more