Elf7535 Parts

Traps lint, debris, and small objects during wash cycles to protect your washer's drain pump from clogs. Replace if draining slows or stops. Verify fit.

Washer won't drain or leaves clothes soaking wet? A faulty drain pump prevents water removal after wash cycles. Direct-fit replacement, moderate DIY.

Secures hoses to pumps, tubs, and valves preventing leaks. Replace if worn, loose, or causing drips during cycles. Confirm fit with your model number.

Prevents water leaks around your washer door. Replace if you notice puddles, moisture buildup, or visible cracks. Confirm fit with your model number.

Replace your dryer seal to prevent air leaks, heat loss, and moisture escape. Restores tight barrier for efficient drying. Check fit with your model.

If your dryer runs too hot, won't heat properly, or shuts off unexpectedly, the inlet thermistor may have failed. This sensor monitors incoming air temperature.

10-inch heating element that restores proper heat production in affected appliances. Replaces a worn or failed element to help resolve issues like no heat or unusually long cycle times. What it does:

• Generates heat so your appliance can reach normal operating temperatures.
• Common symptoms it addresses: little or no heat, longer-than-normal cycles, or intermittent heating.
• Replaces a single failed element to return consistent heating performance.

What's included: One heating element. Install notes:

• Disconnect the appliance from power before attempting any repair.
• Allow the element to cool and handle carefully to avoid bending or damaging the coil.
• Ensure the terminal connections are secure and free of corrosion; tighten or replace fasteners as needed.

NOTE: IF THERMISTOR HAS TERMINALS WIRE HARNESS HAS TO BE CHANGED PART# 137288900 PER FRIGIDAIRE

Fix detergent or fabric softener not dispensing properly with this washer dispenser cup assembly. Restores proper distribution of laundry products.

Dryer not heating properly or overheating? The thermistor monitors temperature and signals the control board. Common DIY repair, takes 15-30 minutes.

This handle assembly replaces a damaged or worn refrigerator door handle, restoring a secure grip and normal door operation. It provides an OEM-fit replacement that mounts in the factory handle location for a neat, finished look. What it does:

• Replaces a broken, cracked, or loose refrigerator door handle
• Restores a solid grip for opening and closing the door
• Helps prevent further damage to the door trim or handle mounting area
• Keeps the cabinet appearance consistent with the original finish

• Disconnect power and remove food from the door area before starting work
• Use appropriate hand tools to remove mounting screws or caps; retain fasteners for reassembly
• Align assembly with mounting posts and secure without over-tightening to avoid cracking
• If door trim or mounting hardware is damaged, inspect and replace as needed for a secure fit

Replacement mounting screw for dryers. Secures panels, brackets, and internal components. Replace if stripped, missing, or corroded during repairs.

Fix unresponsive controls or cycles that won't start with this dryer electronic control board. Manages all major functions and user commands.

Burner orifice that meters gas flow to your dryer's burner. Replace if clogged, damaged, or wrong size for fuel type during LP/natural gas conversion.

Replacement door glass for dryer doors. Provides a clear viewing window to monitor laundry during cycles. Order when glass is cracked, broken, or missing.

Fix a dryer that won't heat or takes too long to dry clothes with this dual-element heating assembly. Restores proper heat output and even drying.

Dryer not starting or power cutting out? A melted or corroded terminal block disrupts power flow. This 3-terminal block restores secure connections. DIY-friendly repair.