Elf7535 Parts

Hex washer head ,10-32 x 0.375. Ground

Replace your dryer door seal gasket to prevent heat loss and improve drying efficiency. Worn gaskets cause longer cycles and higher energy costs. Verify fit with your model number before ordering.

Control knob for dryer cycle selection and temperature settings. Replaces cracked, broken, or missing knobs. Installs on control panel.

Replacement mounting screw for dryers. Secures panels and internal components. Needed when original screw is stripped, damaged, missing, or causing loose parts.

Dryer won't start or stops mid-cycle? This electronic control board assembly restores proper cycle operation and user interface functionality.

Replacement screw for securing dryer trim, panels, and interior components. Needed when original fastener is lost, stripped, or damaged during repair.

This metal top panel replaces the upper rear control housing on compatible Frigidaire ranges and stoves, restoring a secure mounting surface for controls and improving cabinet fit and appearance. Ideal for repairing bent, rusted, or damaged panels. What it does

• Replaces the upper rear housing that supports control knobs, switches and the backguard area
• Restores proper alignment and spacing between the cooktop and rear controls
• Stops light leaks and relieves stress from warped or bent panels
• Commonly used when the panel is dented, rusted, cracked, or has broken mounting tabs

• One top panel

• Disconnect power (and gas, if applicable) before starting any work
• Handle sharp sheet-metal edges with gloves; panel edges can be sharp
• Remove control knobs, backguard, or trim as required and save screws for reinstallation
• Align mounting tabs and secure with original hardware; test controls after reassembly

Round black control knob for dryer control panel. Replaces worn, faded, cracked, or missing knobs to restore setting selection and appearance.

Dryer won't start or drum won't turn? This drive motor assembly powers the drum and blower. Moderate difficulty repair, typically 1-2 hours.

This gasket forms an airtight seal around the dryer's blower housing to ensure proper airflow through the exhaust system. It prevents heated air from leaking into the dryer cabinet instead of being directed out the vent. Replace this gasket if the dryer takes too long to dry clothes, the cabinet feels excessively hot, or you notice air leaking around the blower area.

If your dryer overheats or won't heat properly, the temperature probe may have failed. This sensor monitors internal temperature for accurate heating.

Replace your dryer's exhaust duct if cracked, damaged, or misaligned. Routes airflow from drum to exterior vent opening. Restores proper ventilation.

Dryer frame assembly that forms the structural housing for your dryer. Replace if cracked, warped, or damaged to restore cabinet integrity and support.

Door gasket that seals the dryer drum opening to prevent heat and lint escape. Maintains proper drying temperature and keeps lint contained. Replace if torn, hardened, or no longer sealing.

This replacement nozzle assembly directs and controls water flow in the appliance, restoring proper delivery to the dispenser or ice-making components. It replaces a worn or damaged nozzle to help stop leaks and restore consistent flow. What it does

• Directs water from the supply line to the dispenser or ice-making fill tube.
• Helps stop spraying or leaking when the original nozzle is cracked or blocked.
• Restores steady water flow when the dispenser produces weak or intermittent water.
• Fits into the original mounting and seals the water path when properly installed.

• One nozzle assembly as shown.

• Turn off water supply and unplug the appliance before starting work.
• Inspect surrounding seals and tubing; replace any damaged parts to ensure a proper seal.
• Hand-tighten fittings and check for leaks after restoring power and water.