Er36dsch Parts

This illuminated service knob replaces a worn or damaged control knob to restore a visible, easy-to-use control point on your appliance. It provides the same look and basic control function as the original part. What it does:

• Replaces a damaged or faded control knob so settings can be selected and seen clearly
• Illuminated design improves visibility in low light and matches factory appearance
• Fits the original control shaft and detents for reliable selection feel
• Helps address symptoms like loose, cracked, non-illuminating, or cosmetically worn knobs

• 1 illuminated service knob

• Disconnect power to the appliance before starting any work to avoid shock or injury
• Pull the old knob straight off the control shaft; push the replacement knob onto the shaft until it seats
• If illumination does not work after replacement, verify lamp/LED and wiring with the model-specific service instructions

This straight bake burner replaces the oven's lower gas burner to restore consistent bake heat and flame. It installs in the oven floor and connects to the regulator and igniter assembly for normal gas flow to the bake chamber. What it does:

• Provides the primary gas flame for the oven's bake function
• Restores even baking when the oven fails to reach or hold set temperatures
• Replaces corroded, warped, or damaged burner tubes that produce weak or irregular flames
• Helps eliminate yellow or sputtering flames caused by burner damage or blockage

• One straight bake burner assembly

• Shut off power and gas supply before beginning service; follow all local codes
• Basic hand tools are typically required; gentle handling prevents deformation of the burner tube

This burner gasket seals the cooktop burner to help stabilize the burner head and limit debris or soot build-up for more consistent cooking. It's a direct-fit service seal used during burner maintenance or replacement. What it does:

• Provides a tight seal between the burner head and cooktop surface to keep crumbs and spills out of the burner area
• Helps keep the burner seated and stable for consistent heat distribution
• Reduces visible soot and debris accumulation around the burner
• Can improve burner appearance by closing gaps and preventing food intrusion
• Common symptom: visible gap around the burner, excessive soot, or a burner that wobbles

• One burner gasket (single)

• Turn off gas supply and power to the appliance before beginning work
• Remove the burner cap and head per the manufacturer's instructions to access the gasket
• Seat the new gasket evenly around the burner before reassembling components
• After reinstalling, restore power/gas and observe the burner for proper seating and normal flame behavior; stop if you detect unusual gas odor or flame issues

This service end cap is a chrome-finish replacement trim piece that restores the appliance's finished appearance and protects the exposed end of the control/trim area from dirt and damage. It matches OEM fit and finish for a seamless repair. What it does:

• Covers and protects the exposed end of the control/trim assembly to prevent dirt, moisture, and wear
• Restores the appliance's original appearance where the end cap is cracked, scratched, or missing
• Helps maintain a secure edge on the control/trim area for proper alignment
• Simple cosmetic replacement to improve appearance after panel or control repairs

• One chrome-finish service end cap

• Disconnect power to the appliance before starting any work
• Installation typically involves removing adjacent trim or a few fasteners; handle trim pieces gently to avoid damage
• Align tabs and clips, then press or fasten the end cap into place without forcing