Fafw4221lwo Parts

Replacement #8 x 0.500 inch screw for securing panels, trim, and brackets in appliances. Needed when original fasteners are stripped, lost, or missing.

Replacement bolt fastener for securing washer panels, brackets, and assemblies. Needed when original bolt is missing, loose, or stripped causing rattling.

Support plate for washer components. Mounts internally to secure parts in place. Replace if cracked, bent, or broken to restore proper structural support.

Mounting screw for washer cabinet and component assembly. Replace if screw is stripped, missing, or damaged during disassembly. Essential hardware piece.

Secures hoses in your laundry center. Replace if cracked, loose, or causing leaks. Confirm fit with your model number before ordering.

Replacement mounting nut that secures panels, trim, and internal components. Needed when original nut is stripped, corroded, missing, or lost during repair.

Spring mounting bracket for washers. Secures suspension springs to the washer tub or frame. Replace if bracket is cracked, bent, or broken from load stress.

This bushing protects the appliance service cord where it passes through the cabinet, reducing wear and preventing chafing that can expose wiring. It's a simple replacement that restores a safe cord entry point. What it does:

• Cushions and centers the service cord at the cabinet opening to prevent abrasion
• Helps keep the cord from rubbing on sharp metal edges that can cause insulation damage
• Reduces risk of shorting, sparking, or intermittent power caused by a worn cord
• Commonly replaced when the existing bushing is cracked, missing, or deformed

• One service cord bushing

• Disconnect power (unplug or switch off breaker) before servicing
• Inspect the cord and surrounding insulation; replace the cord if damage is found
• Push the bushing into the cabinet opening, then route the cord through the bushing until seated
• Reuse only if undamaged; do not force a damaged bushing into place

Secures and organizes wires inside your appliance. Replace if broken, loose, or missing to prevent wire damage. Verify fit with your model number.

Washer hose clamp secures water inlet and drain hoses to prevent leaks. Replace if loose, cracked, or causing water drips. Verify fit with your model number.

Harness cable tie secures and organizes wiring inside your appliance. Replace if damaged, cracked, or no longer holding wires firmly in place.

This cap is a small protective cover designed to fit over electrical terminals and exposed fittings to help keep dirt, moisture, and accidental contact away from sensitive components. It restores a finished appearance and basic protection. What it does:

• Covers and insulates exposed electrical terminals or connector ends to reduce short risk from accidental contact
• Helps keep moisture, dust, and debris off connections that can cause corrosion over time
• Maintains a secure fit over the terminal to prevent snagging or loose wiring
• Useful when replacing a damaged or missing terminal cover to restore proper protection

• Disconnect power to the appliance before working on electrical components
• Push the cap fully over the terminal until it seats; do not force or modify the part
• If wiring or terminals are corroded or damaged, replace or repair the wiring before installing the cap

Flexible gasket sealing washer door to drum, preventing leaks during cycles. Replace when torn, leaking, or showing mold buildup. Confirm fit.

Fix E53 errors, no spin, or drum not moving. This motor control board restores washer operation. DIY repair in 45 minutes with our installation video.