Fef336vgwd Parts

Heat shield for electric and gas ranges. Mounts inside the range to protect components from heat damage. Replace if cracked, warped, or missing.

Shield protects the wire harness near the vent tube in your range. Replace if cracked, damaged, or missing to prevent wire exposure and ensure safe operation.

Replace your range's heat shield if it's cracked, warped, or missing. This protective barrier installs between heating elements and components.

Mounting bracket for electric and gas ranges. Secures components in place. Replace if bent, cracked, or broken to restore proper fitment and stability.

Push-in plug button that covers openings in the oven bottom panel. Replace if cracked, missing, or broken to keep debris out and maintain a clean finish.

Insulation shield for electric ranges. Installs to protect internal components from heat. Replace if cracked, damaged, or missing for proper insulation.

Replacement door trim kit for your gas range. Installs around the door perimeter to cover edges and provide a finished appearance. Needed when original trim is cracked, broken, or missing.

Replace the channel trim on your range door when it becomes cracked, broken, or damaged. This structural component installs along the door edge for a secure fit.

Black hinge washer for electric and gas ranges. Replaces worn, cracked, or missing washers on door hinges to ensure proper door alignment and support.

A replacement wire shield for the stove/oven vent that protects wiring from heat and abrasion, helping maintain reliable oven vent performance and reduce wire damage risk. What it does:

• Shields vent-area wiring from heat and physical wear
• Helps prevent wiring chafe and shorting caused by rubbing or contact
• Supports safe routing of harnesses near the stove/oven vent
• Addresses symptoms such as exposed or frayed wires near the vent, burning smell, or intermittent electrical faults

• One wire shield as shown

• Disconnect power to the appliance before attempting any service
• Handle carefully to avoid bending or nicking the shield or adjacent wiring
• Reinstall using existing mounting points and fasteners; replace any damaged clips or hardware