Fft1814q Parts

Front grille panel for room air conditioners. Covers the unit's front and directs airflow. Replace if cracked, broken, or discolored from age.

This evaporator coil circulates refrigerant inside the freezer compartment to absorb heat and enable the cooling cycle. Replacing a damaged or corroded coil restores proper cold distribution and helps the appliance reach normal temperatures. What it does:

• Absorbs heat from the freezer compartment as part of the refrigeration cycle
• Allows refrigerant to evaporate and carry heat away from the cabinet
• Commonly replaced for frost buildup, poor cooling, or visible coil damage
• Works with the evaporator fan and defrost system to maintain even temperatures

• One evaporator coil as shown

• Requires access to the freezer back panel; follow for step-by-step removal
• Disconnect power before servicing to prevent shock or compressor damage
• Handle refrigerant lines carefully; if refrigerant must be opened, recover/recharge system
• Inspect surrounding components (evaporator fan, defrost heater/thermostat) while replacing for best results

If your air conditioner won't start or runs intermittently, the capacitor may have failed. This part provides the voltage boost needed for startup.

Replace your dryer's broken or missing start knob. This control dial installs on the front panel to restore operation of the start cycle function.

This is a replacement pan-head, locking screw used to secure the top bracket on compatible Frigidaire appliances. It provides a reliable fastener that helps keep the top bracket and panels held firmly in place. What it does:

• Secures the top bracket to the cabinet or chassis to prevent bracket movement or rattling
• Restores proper alignment of top panels and trim that may be loose or sagging
• Uses a locking feature to resist loosening from vibration
• Pan head design provides a low-profile, finished appearance once installed

• One screw as shown

• Use the matching #8-32 driver or bit and tighten until snug; avoid over-torquing to prevent stripping
• Turn off power and remove panels as needed before accessing the bracket area
• Replace only with the same size and thread type to ensure secure fit
• Replace all related screws for even support

This small retainer clip secures trim, panels, or components in place to prevent rattling and keep parts aligned. It's a simple replacement that restores proper fit and reduces vibration or loose panels. What it does:

• Holds appliance trim or panel pieces in position to prevent movement and noise
• Helps keep wiring or small components routed and secured away from moving parts
• Stops gaps or misalignment that can cause rubbing or vibration sounds
• Restores the intended fit where a worn or broken clip allows play

• Disconnect power to the appliance before starting any repair
• Access the clip location by removing the applicable trim or panel per your model's service instructions
• Use common hand tools; replace broken clips with the identical style to ensure proper fit
• Replace all matching clips for consistent fit

Suspension spring for dryers. Supports the drum and absorbs vibration during operation. Replace if stretched, broken, or causing excessive drum movement.