Fg4h2272 Parts

Ice bucket assembly for refrigerator freezers. Stores and dispenses ice cubes from the icemaker. Replace if cracked, damaged, or broken from wear.

Small retainer clip that secures components, panels, tubes, or wires in place inside your refrigerator. Replace when worn, broken, or missing to restore fit.

This fan motor-and-blade assembly restores airflow in compatible Frigidaire refrigerators and freezers to help maintain even temperatures and reduce warm spots. It replaces a failed fan to improve circulation and appliance performance. What it does:

• Circulates air inside the fresh food and freezer compartments for more even cooling.
• Moves air across cooling components to help prevent localized frost and warm zones.
• Replaces noisy, stalled, or non-spinning fans that cause reduced cooling or unusual sounds.
• Supports proper airflow so the appliance can maintain set temperatures more consistently.

• Disconnect power before starting—unplug the appliance or shut off the circuit breaker.
• Access typically requires removing interior panels or the rear evaporator cover; retain fasteners.
• Handle blades carefully to avoid bending; ensure electrical connectors are fully seated.

This is a left-side crisper drawer assembly designed to fit in the lower section of the refrigerator compartment. It holds fruits and vegetables in a humidity-controlled environment to keep produce fresh longer. Replace this drawer if it is cracked, warped, or if the slides no longer allow it to open and close smoothly.

Secures the door handle to your refrigerator. Replace if screw is stripped, missing, or loose causing handle to wobble or detach from the door.

Fixes excessive frost buildup and ice on evaporator coils. This defrost heater melts accumulated ice to restore proper airflow and cooling performance.

Replace your dim or flickering refrigerator interior LED light assembly for bright, clear visibility. Essential when light fails or flickers. Verify fit with your model number before ordering.

This #8-32 x 3/8 screw secures appliance panels, brackets, and assemblies. Replace a missing or stripped fastener to keep parts tight and aligned, reduce vibration, and restore proper fit in compatible refrigerators and freezers.

• Machine-thread fastener sized #8-32, 3/8-inch length
• Secures control housings, trims, covers, and support brackets per model design
• Replaces missing, worn, or corroded screws that cause loose or rattling parts
• Helps maintain alignment and stability after service

• Unplug the appliance; shut off water if applicable
• Match thread size to the original and start by hand to avoid cross-threading
• Use the correct driver; do not overtighten, especially into plastic
• Verify component alignment and operation after fastening

• Thread size: #8-32
• Length: 3/8 inch

Water dispenser tube for bottom-mount refrigerators. Connects water supply to dispenser mechanism. Replace if cracked, leaking, or kinked.

Replacement control panel cover that restores a finished look to your refrigerator. Replaces cracked, broken, or missing panels to protect controls.

Structural housing for refrigerator icemaker components. Replace if cracked, broken, or damaged. Supports water routing and internal alignment.

Rubber grommet that cushions components and reduces vibration in your refrigerator. Replace when worn, cracked, or causing noise. Confirm fit with model number.

Seals the refrigerator door to keep cold air in and warm air out. Replace if worn, torn, or loose to restore efficiency. Confirm fit with your model.

This is a water tube guide used in the dispenser area of a refrigerator. It routes and secures the water supply tubing so water flows properly to the dispenser nozzle. Replace this guide if the water tube is kinked, misaligned, or if you notice reduced water flow or leaking near the dispenser.

Control wire harness routes power and signals between your refrigerator's control board and components. Replace if experiencing electrical issues or flickering.

This refrigerator nameplate displays model information, specifications, and branding on your appliance's exterior. It provides important identification details for service and warranty purposes. Replace if the nameplate is missing, illegible, or damaged to maintain proper appliance identification.