Fgh3054us Parts

Replacement mounting screw for refrigerator panels, brackets, and trim. Secures loose or missing fasteners to stop rattles and keep components aligned.

Replacement mounting screw secures trim, brackets, and panels inside your refrigerator. Restores proper fit when original screws are missing or stripped.

Replacement nameplate label for refrigerators. Restores model, serial, and electrical rating information when original is faded, peeling, or missing.

Metal or plastic channel that mounts and aligns refrigerator shelves or door bins. Replace if cracked, broken, or no longer securing shelves properly.

Fix ice buildup and frozen water dispenser issues with this dispenser heater kit. Prevents frost clogging in the chute and valve area. Moderate DIY repair.

Supports the compressor on the refrigerator's rear base. Replace if cracked, broken, or worn to keep compressor properly seated and reduce vibration damage.

Hinge cam assembly that enables smooth self-closing door action. Installs on the door hinge. Replace if cracked, worn, or broken to restore proper closing.

Rubber grommet that mounts and cushions the compressor to reduce vibration transfer. Replace if cracked, worn, or missing to restore quiet operation.

Secures refrigerator grille or trim to cabinet, preventing rattles and gaps. Replace when broken or missing to restore proper panel alignment. Verify fit with your model number before ordering.

Single mounting screw secures trim, panels, or brackets inside your refrigerator. Replace lost, stripped, or damaged screws to keep components firmly attached.

Replaces worn or damaged shaft support bushing in your refrigerator. Cushions rotating shafts to reduce friction and noise. Order a new bushing today.

This solenoid actuator is the electromechanical device that moves a latch or linkage when energized, restoring the appliance's intended mechanical action. It provides a direct replacement to re-enable reliable actuation. What it does:

• Converts electrical signal into a mechanical push or pull to operate a latch, door, dispenser or linkage
• Commonly used where a timed or motor-driven movement is needed during a cycle
• Symptoms this part can cause: appliance fails to actuate a door, latch, dispenser or similar mechanism when called for
• Replacing a worn or failed actuator restores proper mechanical response to control signals

• One solenoid actuator

• Disconnect power to the appliance before beginning work to avoid shock or unintended actuation
• Remove any panels or trim as needed to access the actuator; note wire and mounting locations for reassembly
• Reconnect wiring and test the function on a short cycle after installation

This is a small electric motor that drives the ice maker's ejector mechanism, rotating the sweep arm to push ice cubes out of the mold and into the storage bin. It is mounted inside the ice maker module in the freezer compartment. Replace this motor if your ice maker stops cycling, fails to eject ice, or you hear the motor humming without the ejector arm moving.

Replace a cracked or missing protective trim cover on your refrigerator. This cover shields internal components from dirt and restores a clean look.

Refrigerator not cooling properly? This condenser coil assembly removes heat from refrigerant to restore cooling performance and improve efficiency.

Mounts inside refrigerator to limit door travel and maintain proper alignment. Replace if cracked, broken, or missing to restore correct door positioning.