Fghg2366fp0 Parts

Replacement mounting rail that supports and secures refrigerator shelves. Install when your shelf channel is cracked, bent, or allows shelves to slide out.

Covers and protects the upper door hinge area on your refrigerator. Replace if cracked, broken, or missing to restore a finished look.

Water inlet tube for bottom-mount refrigerators. Connects water supply to dispenser system. Replace if cracked, leaking, or damaged. Direct fit part.

Secures the evaporator or condenser fan shroud to the refrigerator cabinet. Replace this mounting screw if stripped, missing, or broken during repair.

Refrigerator door guide channel that helps align and support the door mechanism. Replace if cracked, broken, or worn to restore proper door alignment.

Lower door hinge for bottom-mount refrigerators. Secures the door to the cabinet frame. Replace if cracked, stripped, or causing door misalignment.

This is a gasket that seals around the upper evaporator cover inside the freezer compartment. It helps maintain proper airflow and prevents warm air from bypassing the evaporator coils. Replace this gasket if you notice excessive frost buildup in the freezer, inconsistent cooling, or if the gasket appears torn, warped, or no longer seals tightly against the evaporator cover.

Seals the coil cover area to maintain proper airflow and prevent dust buildup. Replace if worn, cracked, or losing seal efficiency. Verify fit with your model.

This tube connector is a small water-line fitting that joins refrigerator water and ice-maker tubing, restoring a secure path for water flow. It helps stop leaks and regain consistent water delivery to the dispenser or icemaker. What it does:

• Joins two sections of refrigerator water tubing to maintain a watertight connection
• Stops leaks at a damaged or worn tube joint
• Restores water flow to the ice maker or dispenser when a broken connector is the cause
• Compatible with rigid and soft tubing in typical refrigerator plumbing layouts

• One tube connector

• Shut off the refrigerator water supply before servicing
• Inspect tubing ends and replace damaged tubing or seals as needed
• Use proper fittings and tighten to manufacturer torque; avoid over-tightening

Foam sleeve insulation that wraps around the refrigerator air duct. Replace worn, torn, or missing insulation to reduce condensation and moisture buildup.

Mounting screw for refrigerator components and panels. Replace if stripped, missing, or damaged during repairs to secure parts properly.

Foam insulation installs in refrigerator cabinet walls and interior surfaces. Replace if cracked, compressed, torn, or missing to restore efficiency.

Replacement mounting screw for refrigerators, ovens, ranges, and cooktops. Secures interior panels, components, and trim. Needed when original is stripped, missing, or damaged during repair.

Freezer drawer slide assembly for your refrigerator. Replaces broken, cracked, or malfunctioning slides that cause drawer movement issues. Easy DIY fix.

This ice ejector is the plastic arm that pushes cubes out of the ice maker mold and into the ice bin, restoring proper ice ejection and dispenser function. It's a direct-replacement component for affected ice maker assemblies. What it does:

• Physically strips and pushes formed ice cubes from the mold into the bin or dispenser
• Helps restore normal ice dispensing when cubes remain stuck in the mold
• Works with the ice maker's motor/gear train to time ejection during the harvest cycle
• Commonly replaced when the ejector is broken, cracked, or worn and no longer contacts cubes

• One ice ejector (ejector arm)

• Disconnect power to the refrigerator before starting any repairs
• Remove the ice maker/cover or access panel as required to reach the ejector
• Inspect related components (drive gear, motor, and mounting pins) for wear while replacing the ejector
• After installation, run a test harvest/dispense cycle to correct operation