Fgid2474qfob Parts

Note: Contains Left Hand and Right Hand hinges.

A replacement holder-style mounting bracket that secures and positions internal components in the appliance, restoring proper fit and function. Helps keep parts aligned so doors, drawers, or assemblies operate smoothly. What it does

• Provides a secure mounting point to hold an internal component or trim piece in place
• Restores proper alignment to reduce rubbing, rattling, or looseness
• Supports correct positioning that helps seals, doors, or assemblies close and operate as intended
• Durable molded construction resists wear in normal use

• One holder (mounting bracket) as pictured

• Designed to install in the original mounting location using existing screws or clips; replace like-for-like
• Inspect mating surfaces and fasteners for damage before installing; replace any worn hardware
• Disconnect power to the appliance before servicing components in electrical or refrigerated compartments

This wiring harness connects electrical components to restore power and signal paths so affected appliance circuits operate correctly. It replaces a damaged or worn harness to help resolve intermittent or lost electrical connections. What it does

• Provides reliable electrical connections between controls, motors, and sensors
• Carries power and control signals to restore component function
• Common symptoms it can address: components not powering on, intermittent operation, or control panel not responding
• Replaces frayed, burned, or broken wire bundles and connector assemblies

• Disconnect power to the appliance before inspecting or replacing the harness
• Compare the harness and connector locations to the parts diagram to ensure correct routing and fit
• Secure connectors fully and avoid pinching wires during reassembly
• If corrosion or other component damage is present, inspect and replace affected parts as needed

This clamp secures a hose or small tubing to keep it in place and reduce movement or vibration. It helps prevent rubbing, kinking, and minor leaks by holding connections tight where a molded clip or screw clamp is required. What it does:

• Holds water or drain hoses, vent tubing, or small lines firmly in place
• Prevents rubbing and vibration that can cause premature wear or noise
• Helps maintain a sealed connection that reduces the chance of minor leaks
• Stops hoses from shifting out of position during normal operation

• Disconnect power and turn off water supply before accessing the component area
• Remove any access panels needed to reach the hose or tubing; use appropriate pliers or a screwdriver if applicable
• Position clamp over the tubing and secure so the hose is held without pinching; verify there is no kinking
• After installation, restore power/water and run a short test to check for proper fit and leaks

The Manifold is an OEM component specifically designed for Frigidaire dishwashers, evenly distributing water throughout washing cycles. This assembly contains precision-molded tubing. 

Symptoms of a bad manifold include:

• Reduced spray pressure weakening wash performance
• Distorted tubing restricting the consistent flow  
• Leaks from corroded junctions along connections
• Loose mounts losing secure installation

Causes of failure involve mineral buildup narrowing passageways over time, cracked joints from repeated heating and cooling, or damaged anchors failing to isolate vibrations.

Replace yours today with this genuine OEM Frigidaire manifold to restore full flow capacity. Compatible with Electrolux, Gibson, and select Kenmore models as well, its reinforced design maintains optimum water circulation and balance. Reliable plumbing sustains powerful cleaning for the lifetime of your unit.