Fgus2646lf1 Parts

Basket trim for side-by-side refrigerators. Installs around storage basket edges to provide a finished look. Replace if cracked, broken, or missing.

Refrigerator door guide channel that helps align and support the door mechanism. Replace if cracked, broken, or worn to restore proper door alignment.

This solenoid actuator is the electromechanical device that moves a latch or linkage when energized, restoring the appliance's intended mechanical action. It provides a direct replacement to re-enable reliable actuation. What it does:

• Converts electrical signal into a mechanical push or pull to operate a latch, door, dispenser or linkage
• Commonly used where a timed or motor-driven movement is needed during a cycle
• Symptoms this part can cause: appliance fails to actuate a door, latch, dispenser or similar mechanism when called for
• Replacing a worn or failed actuator restores proper mechanical response to control signals

• One solenoid actuator

• Disconnect power to the appliance before beginning work to avoid shock or unintended actuation
• Remove any panels or trim as needed to access the actuator; note wire and mounting locations for reassembly
• Reconnect wiring and test the function on a short cycle after installation

Wiring harness for side-by-side refrigerators. Connects electrical components inside the unit. Replace if wires are frayed, damaged, or broken.

Refrigerator light staying on or not turning on? This door switch signals when the door opens or closes. Direct replacement part, basic DIY repair.

Fix a refrigerator that's not cooling properly with this evaporator coil kit. Restores proper cooling when the evaporator fails or frosts over.

This ice ejector is the plastic arm that pushes cubes out of the ice maker mold and into the ice bin, restoring proper ice ejection and dispenser function. It's a direct-replacement component for affected ice maker assemblies. What it does:

• Physically strips and pushes formed ice cubes from the mold into the bin or dispenser
• Helps restore normal ice dispensing when cubes remain stuck in the mold
• Works with the ice maker's motor/gear train to time ejection during the harvest cycle
• Commonly replaced when the ejector is broken, cracked, or worn and no longer contacts cubes

• One ice ejector (ejector arm)

• Disconnect power to the refrigerator before starting any repairs
• Remove the ice maker/cover or access panel as required to reach the ejector
• Inspect related components (drive gear, motor, and mounting pins) for wear while replacing the ejector
• After installation, run a test harvest/dispense cycle to correct operation

Replaces your refrigerator's ice maker cover if cracked, broken, or missing. This protective cap installs on the ice maker assembly in your freezer.

Corner trim kit for refrigerator installation. Replaces cracked, broken, or missing corner trim pieces. Cosmetic finishing component for cabinet fit.

Protective housing cover for the refrigerator temperature sensor. Mounts on the fresh food compartment wall. Replace if cracked, broken, or missing.

Replacement air guide duct for side-by-side refrigerators. Directs cold air flow between compartments. Order a new one if cracked or broken.

Upper hinge cover cap for refrigerators. Conceals and protects the top door hinge mechanism. Replace if cracked, broken, discolored, or missing.

Replace a cracked, broken, or missing upper hinge cover on your refrigerator. This decorative cap conceals the hinge mechanism for a clean look.