Frigidaire Affinity Front Loader Parts

This replacement door glass forms the clear window in the door of select front-load units, restoring safe visibility and proper door fit. Replace a cracked, chipped, or shattered pane to prevent leaks and ensure the door seals and latches correctly. What it does

• Creates the viewing window in the door and mates to the door gasket/boot
• Helps maintain a proper seal to contain wash action
• Restores safe operation when the original glass is damaged
• Common symptoms: visible cracks or shattering, water leaking from the door area, door not closing flush, rattling glass

• 1 door glass pane

• Disconnect power and turn off water supply before service
• Wear cut-resistant gloves and eye protection; handle glass carefully
• Remove the door, set it on a padded surface, and transfer trim/gasket as designed
• Tighten fasteners evenly and check gasket alignment to prevent leaks

Secures the fan housing to its mounting points. Replace if the clip is broken, missing, or worn to eliminate rattles and prevent air leaks in your dryer.

Fix a dryer that won't start or respond to controls. This electronic control board restores button functions and cycle selection. DIY-friendly repair.

This is the main electronic control board that manages all washer functions, including cycle selection, water fill, motor operation, and spin speed. It is typically mounted inside the control panel or rear of the machine and connects to the various components via wire harnesses. Replace this board if the washer fails to start, stops mid-cycle, displays error codes, or if buttons and cycle selections are unresponsive.

This is a flexible seal that fits around the inner door glass of the dryer, creating an airtight barrier between the door panel and the drum area. It prevents heated air from escaping and keeps lint contained within the drum during drying cycles. Replace this gasket if you notice heat leaking from around the door, longer drying times, or if the seal is cracked, torn, or coming loose.

Rubber grommet cushion for laundry center washers. Isolates vibration and prevents wear where components pass through openings. Replaces worn or missing.

Fix a washer that loses power, won't spin properly, or has an unresponsive control panel. This electronic control board restores normal operation.

Restores proper tension to washer mechanisms. Replaces worn, broken, or stretched springs causing binding, sagging, or uneven movement in drum suspension.

Rubber O-ring seal prevents water leaks at hose connections and fittings. Replace when worn or cracked to restore tight seal and stop dripping. Verify fit.

This damper is the refrigerator air-control flap that regulates airflow between compartments to help maintain consistent temperatures and proper cooling. It replaces a worn or stuck damper to restore normal airflow and temperature balance. What it does:

• Opens and closes to direct cold air where needed between freezer and fresh-food sections
• Helps maintain even temperatures and prevents one compartment from getting too warm
• Common symptom: uneven cooling or warm fresh-food section despite running compressor
• Common symptom: damper stuck or not moving, causing poor temperature control

• Disconnect power to the appliance before starting any repair
• Remove interior panels to access the damper; use basic hand tools
• Handle the damper and any wiring harness carefully to avoid damage
• After installation, verify damper operation and allow time for temperatures to stabilize

Connects your washing machine to the household water supply. Replace this flexible inlet hose if cracked, leaking, or worn to restore proper flow.

Secures hoses on your washer to prevent leaks and water damage. Replace if loose, cracked, or during hose repairs. Verify fit with your model number.

Sound dampening insulation that reduces vibration and noise in your washer. Replace if worn, torn, or missing to restore quiet operation and protect components.