Fws445rf2 Parts

Agitator rod and gear kit for washers. Connects the agitator to the drive system. Replace if gears are stripped, worn, or rod is broken or damaged.

This door gasket creates a tight seal around the refrigerator door to help maintain proper cooling and reduce energy loss. Replacing a worn gasket restores a full seal for better temperature control and food preservation. What it does:

• Seals the door to prevent warm, humid air from entering the refrigerated compartment
• Helps reduce frost buildup and keeps interior temperatures stable
• Improves cooling efficiency and can lower energy use caused by a leaking seal
• Stops odors and moisture transfer between the fridge interior and kitchen

• Unplug the refrigerator before starting and remove any food or shelves blocking the seal.
• Work slowly to avoid stretching or creasing the gasket; follow door-hinge or trim removal steps if needed.
• Inspect the door flange for damage and clean the mating surface before installing the new gasket.
• After installation, allow the gasket to seat fully and check for uniform contact around the door; warm-up or seating time may be needed.

Replace your washer's timer dial if it's cracked, broken, or missing. This control knob installs on the control panel to select wash cycles.

Replacement pump mounting bracket that secures the drain pump assembly to the washer cabinet. Needed when original bracket is cracked, broken, or missing.

Replace your washer's worn or cracked pump grommet. This rubber grommet cushions and seals the drain pump assembly, preventing vibration and leaks.

Replacement pump spacer for washers. Installs between pump components to maintain proper alignment and clearance. Replace if cracked, worn, or missing.

Rubber bumper that cushions the washer door hinge during opening and closing. Replace if cracked, missing, or worn to prevent metal-on-metal contact.

Protective shield that covers and guards the washer pump assembly. Replace if cracked, broken, or missing to prevent debris damage and water spray.

This right-side almond end cap restores the finished look of the appliance trim and protects the exposed end of the handle/door trim from wear. It provides a neat, color-matched replacement for damaged or missing trim. What it does:

• Covers and protects the exposed end of the handle or door trim to prevent further damage
• Restores a finished, color-matched appearance for almond-colored appliances
• Helps keep dirt and moisture out of the trim end, preserving fit and alignment
• Replaces cracked, broken, faded, or missing end caps that affect appearance

• Disconnect power or unplug the appliance before beginning work.
• Remove any screws or trim pieces holding the old end cap in place; the cap typically snaps or fits into position.
• Align the new cap and press or fasten per the original mounting method; do not force or overtighten fasteners.
• If mounting clips or fasteners are damaged, replace them before installing the new cap.

Replace your washer's timer knob if it's cracked, broken, or missing. This control knob attaches to the timer shaft, allowing you to select wash cycles.

Replace your washer's timer dial knob if it's cracked, broken, or missing. This control knob installs on the timer shaft to select wash cycles and settings.