Gas95566as Parts

This control housing is the outer console frame that holds the oven/range control board and user interface, restoring a clean, secure mounting for switches, buttons and the display. It helps keep controls aligned and protected for reliable operation. What it does:

• Secures the electronic control board and control panel components in the appliance console
• Keeps buttons, knobs and display window properly aligned and protected from debris
• Helps prevent intermittent button or display contact caused by a loose or cracked housing
• Addresses symptoms like loose or rattling controls, misaligned buttons, or visible cracks in the console

• Disconnect power (unplug appliance or shut off breaker) before starting any repair
• Remove screws and any trim pieces to access the control housing; handle plastic parts gently to avoid cracking
• Support the control board and wiring when removing the housing to avoid strain on connectors

This condenser kit replaces a refrigerator's damaged or corroded condenser to help restore proper heat dissipation and improve cooling efficiency. It's the direct-fit condenser assembly used in compatible GE refrigeration units. What it does:

• Moves heat away from the refrigerant so the system can cool properly
• Commonly replaced for visible coil damage, corrosion, or bent fins
• Can address symptoms such as reduced cooling performance or longer run cycles
• Works with the existing refrigeration loop when installed correctly

• One replacement condenser kit

• Disconnect power to the appliance before starting any repair
• Access typically requires removing the back or lower rear service panel
• Inspect mounting hardware and electrical connections during installation; follow OEM instructions

This freezer door stop is a small plastic bumper that cushions and limits the freezer door's travel to prevent over-extension and reduce slamming. It restores proper door positioning and helps protect the cabinet edge. What it does:

• Acts as a door bumper/stop so the freezer door closes and rests correctly
• Reduces slamming and wear on the door and cabinet edge
• Helps keep the door aligned during normal opening and closing
• Can resolve symptoms like a door that over-rotates, hits the cabinet, or doesn't seat cleanly

• One white freezer door stop

• Typically installs by snapping or sliding into the hinge/cabinet mounting location; verify orientation before pressing into place
• Turn power to the appliance off only if panel removal is required; this part is non-electrical
• Use basic hand tools if needed and avoid forcing the part to prevent breakage

This wiring harness assembly connects control and electrical components to restore proper signal and power routing within the appliance. Use it to replace damaged or faulty wiring that causes intermittent or failed component operation. What it does

• Routes power and control signals between the control board and major components.
• Replaces frayed, burned, or broken wires to eliminate shorts or open circuits.
• Helps resolve symptoms like no power to components, intermittent operation, or controls that don't respond.
• Maintains correct connector fit and secure electrical connections for reliable performance.

• One wiring harness assembly as shown.

• Disconnect all power before starting any repair to avoid shock or injury.
• Compare the new harness to the original for correct connector types and lengths before installation.
• Route and secure the harness away from sharp edges, moving parts, and heat sources.

This replacement freezer door panel restores the exterior finish and protection to your freezer door, matching the original 18-inch stainless panel for a clean, uniform look and durable surface. What it does

• Replaces a dented, scratched, or corroded freezer door panel to restore appearance
• Provides the finished exterior surface that the door latch and seals mount against
• Helps maintain proper door fit and alignment when the original panel is damaged
• Matches the OEM panel dimensions and mounting points for a direct replacement

• One 18-inch stainless steel freezer door panel

• Designed for direct replacement; check that door is empty and supported before removing the old panel
• Remove power or follow appliance-disconnection procedures per manufacturer instructions before starting
• Handle metal edges and sheet-metal parts carefully; wear gloves and eye protection