Gcr48 Parts

The Bake Igniter is an OEM part for Bosch wall ovens and ranges. Located at the bottom of the oven cavity, it generates the radiant heat needed to initiate the bake burners.

Causes of a bad bake igniter can include failure of the delicate calrod-style heating element from prolonged high-temperature exposure over time.

Symptoms of a bad bake igniter include:

• Inability to ignite or maintain ignition of the bake burners
• Improperly or unevenly heated oven cavity
• Cool or cold spots appearing on bake results
• Igniter glows, but fails to ignite

This genuine OEM Bosch part is also compatible with Thermador, Gaggenau and select Kenmore models.

Protects the oven light bulb and illuminates the cooking chamber. Replace if cracked, discolored, or broken. Confirm fit with your model number.

This door seal creates a watertight barrier between the dishwasher door and tub to contain wash water and steam. Replace a worn gasket to stop drips from the door area and restore a reliable, quiet seal.

• Seals the perimeter of the door to help prevent leaks at the sides and top
• Helps the door close snugly and contain moisture/steam
• Replaces seals that are cracked, flattened, deformed, or shedding pieces
• Typical symptoms: water on the floor near the door, dampness around the door frame, visible wear, door harder to close

• Disconnect power and turn off water supply before servicing
• Pull the old seal straight out; clean the groove/channel of residue and debris
• Warm the new seal to relax it; start at the top center and press it fully into the groove, ensuring corners are evenly seated
• Close the door for several hours to help the seal set, then run a short test cycle and check for leaks

Oven won't heat or element burned out? This high-temperature cut-out fuse interrupts power when temperatures exceed safe levels. Often fails with elements.

Replacement pushbutton micro switch for range control panels. Restores button function when original switch is worn, broken, or unresponsive.

The range push button cap is the outer plastic cap that sits on top of a control panel button, giving you a surface to press when selecting oven functions, temperature, or other settings. It protects the underlying switch mechanism from grease and moisture. Replace this cap if it is cracked, melted, missing, or feels loose and doesn't properly engage the switch beneath it.

Oven not heating evenly or cooking slowly? This convection fan blade circulates hot air for consistent baking. Moderate DIY repair in 30-45 minutes.

Replace your oven door glass spacer if it's cracked, broken, or missing. This spacer sits between glass panels in range oven doors for proper alignment.