Gfg474lvs Parts

Ground wire screw secures grounding conductor to range chassis for electrical safety. Simple 5-minute repair with basic tools. Fits most models.

Replaces the left inner door liner on your range. Install when the original liner is cracked, stained, or damaged to restore a clean door interior surface.

This factory screw secures panels, brackets, or trim within your appliance. Replacing a missing or stripped fastener restores a tight fit, reduces vibration and rattles, and helps keep components aligned for reliable, long-term performance.

• Fastens panels, brackets, or trim to the appliance cabinet/frame
• Replaces damaged, rusted, or missing hardware
• Helps eliminate vibration noises, gaps, and loose-fitting parts
• Supports proper alignment of adjoining components

• Disconnect power; turn off gas/water supplies where applicable.
• Match to the original screw from your model's parts diagram before installation.
• Start threads by hand to avoid cross-threading; use the correct driver bit for the head.
• Tighten snugly—do not overtighten to prevent stripping threads or cracking plastic bosses.

This wiring harness connects appliance controls and components to supply power and signals, restoring reliable electrical paths for normal operation. Designed to replace a damaged or worn harness to help resolve intermittent power or control failures. What it does:

• Routes power and signal connections between the control board and key components
• Replaces cracked, frayed, or corroded wires that cause intermittent operation or no power to parts
• Helps stop shorts or blown fuses caused by damaged wiring
• Restores factory wiring layout for correct component communication

• Disconnect power before inspecting or replacing the harness to avoid shock or damage
• Verify connector orientations and secure all crimps or terminals; ensure proper strain relief
• Check for pin corrosion or bent terminals and replace harness if connectors are damaged

Secures panels, brackets, and internal components in ranges and ovens. Features captive washer for reliable holding. Replace if stripped or missing.

Replacement mounting screw for securing panels, brackets, and internal components. Needed when original screws are stripped, missing, or damaged during repair.

Fix uneven baking and hot spots in your gas oven. This flame spreader restores proper flame distribution for uniform heating and better baking results.

Replace your gas range burner valve if your burner won't light, flame is weak, or heat doesn't adjust properly. Controls gas flow for safe operation.

Self-tapping screw secures panels, brackets, and trim to range frames and housings. Replace worn, missing, or stripped fasteners to restore fit.

Replace a broken or missing door switch actuator rod on your range. This small rod engages the door switch to detect open/closed positions and control the interior light.

Broiler won't ignite or heat? This broiler burner restores high-heat flame for searing and browning. Fits gas ranges with direct-spark ignition systems.

Side trim retainer for range oven doors. Secures trim to door frame. Replace if broken during door glass cleaning or cracked from age and wear.

Fix weak flames or uneven heating with this gas burner orifice holder assembly. Secures the orifice for proper gas flow and stable ignition. DIY repair.

Secures panels, brackets, and trim pieces on ranges and cooktops. Replace if stripped, corroded, or missing to eliminate rattles and looseness.

This is a genuine replacement screw used to fasten panels, trim, and small appliance components. Replacing a damaged or missing screw restores secure mounting and reduces vibration or rattling. What it does:

• Secures panels, brackets, or trim pieces to appliance frames or assemblies
• Prevents loose parts that can vibrate, rattle, or misalign controls
• Replaces stripped, corroded, or lost screws to restore proper fit
• Small hardware solution for routine repairs and maintenance

• Use the matching screw hole and thread carefully to avoid cross-threading
• Hand-start the screw, then tighten with the correct driver until snug; do not over-tighten
• Disconnect power and follow appliance safety procedures before accessing internal parts
• Apply penetrating oil and proceed gently if the original screw is corroded or seized