Ghw9460plo Parts

Rubber grommet that seals where hoses pass through the washer cabinet. Replace if cracked, worn, or missing to prevent water leaks and damage.

Pewter-finish top panel that covers the washer cabinet and protects internal components. Replaces cracked, dented, or discolored original panels.

Right side endcap for washer control panels in pewter finish. Replaces cracked, broken, or missing endcaps to restore the finished appearance.

Strain relief cable for washers. Secures and protects electrical wiring at connection points. Replace if cracked, damaged, or missing to maintain safe wire management.

Inconsistent or improper dispensing of detergent, fabric softener, or bleach This OEM Whirlpool part is also compatible with Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper, and Kenmore models.

This drawer hook is the retainer that keeps an appliance drawer securely seated while still allowing easy release for cleaning or service. Replacing a worn or broken hook restores smooth, reliable drawer operation.

• Secures the drawer in its housing so it stays closed during use
• Acts as the catch/release point for removing the drawer when needed
• Helps maintain proper alignment for smooth opening and closing
• Common symptoms: drawer won't stay closed, pops open or falls out, won't latch, or the hook is visibly cracked/missing

• Disconnect power before servicing
• Fully open and remove the drawer to access the hook area
• Align the new hook with the slots/tabs and snap or seat it into place
• Avoid forcing components; refer to the service manual for model-specific steps

This small retaining fastener locks an assembly, bracket, or panel in place inside your appliance. Replacing a damaged or missing clip helps stop rattles, keep parts aligned, and restore a secure fit.

• Secures a panel, bracket, trim piece, or harness to the appliance frame
• Helps prevent shifting and vibration during operation
• Common symptoms: loose or misaligned parts, rattling noises, or a clip that is cracked, bent, or missing
• Restores proper retention after service or when the original fastener wears out

What's included: 1 clip Install notes:

• Disconnect power before service; for water-using appliances, also shut off the water supply
• Note the original clip's orientation; take a photo before removal
• Use needle-nose pliers or a small flat screwdriver; avoid over-bending the clip
• Replace any additional damaged clips to ensure even retention

This water distribution lever directs spray to the correct wash zones so your dishwasher cleans dishes evenly. It replaces a worn or broken lever to restore proper water routing and reliable wash performance. What it does

• Routes incoming spray water between spray arms or wash zones for correct coverage
• Can prevent weak or uneven cleaning caused by a broken or stuck lever
• Stops water from being sent to the wrong zone when the lever is damaged
• Works as the mechanical linkage that changes water flow path during cycles

• One water distribution lever

• Turn off power to the appliance before starting any repair
• Shut off the water supply and drain remaining water from the unit if applicable
• Basic mechanical replacement—remove access panels and mounting fasteners; align and secure the new lever

Color: Grey.

Color: White.