Glda690pbb-- Parts

A dishwasher sump assembly that houses the pump and routes wash water; replaces a damaged or leaking sump to restore proper draining and circulation. Designed to fit as the factory-style replacement for the original sump. What it does

• Channels and collects wash water for the dishwasher pump to circulate and drain.
• Replaces cracked or warped sump housings that can cause leaks under the appliance.
• Can stop intermittent draining problems or pump cavitation caused by a damaged housing.
• Helps reduce vibration and noise when the pump and housing are functioning correctly.

• One sump assembly.

• Disconnect power and water to the appliance before beginning any repair.
• Inspect surrounding seals, gaskets and fasteners during install; replace any damaged items.
• Tighten mounting hardware to OEM torque and ensure proper alignment to prevent leaks.
• Test or replace those components separately as needed.

This replacement pressure switch hose routes air/suction from the wash tub to the pressure/water-level switch so the machine can detect fill level and run correctly. It restores reliable pressure signal transfer when the original hose is cracked, split, or blocked. What it does:

• Transfers air pressure from the tub to the pressure/water-level switch so the control senses water level
• Helps prevent overfilling or incorrect fill-level detection caused by leaks or clogs in the hose
• Can resolve symptoms like inconsistent fills, washer not completing cycles, or erratic water-level sensing
• Replaces brittle, collapsed, or hardened tubing that no longer seals

• Disconnect power and water before starting any repair; follow all safety guidance for your appliance
• Inspect hose routing and orientation, then slip new hose onto the same fittings with a secure, snug fit
• Replace any damaged clamps or connectors and avoid kinked or pinched hose routing

This fill hose delivers water from the washer inlet valve to the tub, restoring proper water flow and preventing leaks. Replace a cracked, split, or leaking hose to stop water damage and restore normal fill operation. What it does:

• Carries incoming water from the inlet valve to the washer tub during fill cycles
• Stops leaks and water spraying when the original hose is cracked, swollen, or split
• Helps restore normal water fill levels and cycle performance when the hose is failing
• Fits where a direct OEM replacement hose is required for proper seal and routing

• One fill hose

• Turn off water supply and unplug the appliance before starting work
• Inspect inlet valve fittings and hose ends; replace clamps or fittings if worn
• Hand-tighten fittings, then snug with tools—do not overtighten to avoid damage
• Check for leaks after restoring water and power; recheck fittings after a test cycle

This small rubber cushion provides a soft stopping surface to reduce noise, vibration and wear where moving parts contact the cabinet or tub. It helps keep components aligned and running quietly for longer. What it does

• Acts as a bumper between moving parts and the cabinet to reduce rattling and impact noise
• Dampens vibration to prevent premature wear on adjacent parts
• Helps maintain proper spacing and alignment for doors, panels or internal assemblies
• Commonly used where a soft, durable contact point is required

• One cushion as shown

• Disconnect power to the appliance before inspecting or replacing the cushion
• Typically installs by pressing into a slot or onto a mounting post; check exact position before removal
• Replace any worn or torn cushions to restore quiet operation and prevent damage