Gsd4000 Parts

This finished toe kick panel replaces the lower front trim on compatible GE washers and dryers to restore appearance and protect the cabinet base. It provides a clean, finished look and covers the gap between the appliance and the floor. What it does:

• Replaces a damaged, scratched, or bent toe kick to restore the appliance's exterior finish
• Covers and protects the cabinet base from dust, debris, and foot traffic
• Helps maintain a finished, factory appearance after repairs or cabinet work
• Fits where a finished front toe panel is required for proper cosmetic restoration

• Intended for cosmetic replacement; fit to your exact model before installation
• Remove power (unplug or shut off breaker) before accessing panels near controls; follow all safety precautions
• May require removal of lower access panels or screws; retain original fasteners unless replacements are provided

This is a replacement fastener screw used to secure panels and components on compatible appliances, restoring proper fit and reducing movement. It's a simple, direct replacement when an original screw is missing or damaged. What it does:

• Secures access panels, covers, or internal components to prevent rattling and movement
• Helps maintain proper alignment of parts so doors and panels close correctly
• Replaces missing, stripped, or broken screws that can cause loose parts or noise
• Restores the appliance's original fit where a matching OEM fastener is required

• One replacement screw

• Turn off and unplug the appliance before starting any repair
• Use the correct driver and avoid over-tightening to prevent stripping threads
• If the original screw was holding electrical components, ensure power is disconnected and follow OEM safety instructions

Black. 8-18 x 5/16 inch.

Bisque. 8-18 x 5/16 inch.

This long front panel replaces a damaged or worn control-area panel to restore the range's appearance and provide a secure mounting surface for control components. It fits the long control area used on select GE ranges. What it does:

• Replaces cracked, dented or heavily scratched front/control-area panels to improve appearance
• Provides the mounting surface and alignment for control switches and trim
• Helps keep internal components shielded from spills and debris near the controls
• Restores a flush fit where the original panel was warped or bent

• Disconnect power to the appliance (unplug or switch off breaker) before starting work
• Remove control knobs and any trim pieces to access mounting screws; keep original fasteners for reassembly
• Handle the panel carefully to avoid cuts from sharp edges and to prevent cosmetic damage
• Take care when disconnecting and reconnecting wiring;

This inlet cover protects the washer's water valve and inlet area from debris and helps keep hoses and fittings secure for reliable water flow. It's a small replacement part that restores proper sealing and alignment at the inlet assembly. What it does:

• Covers and protects the water valve/inlet area from dirt and impact
• Helps maintain a secure fit for inlet hoses and fittings
• Can reduce or stop water weeping caused by a cracked or damaged inlet cover
• Restores correct alignment of inlet components after damage or wear

• Always disconnect power and shut off the water supply before beginning service
• Remove any retaining clips or screws and note their positions for reassembly
• Handle plastic parts gently to avoid cracking; replace any damaged fasteners

This drip shield is a replacement water-deflecting panel that helps route condensate and drips away from sensitive components to prevent moisture damage and staining. It restores proper water management and helps keep the appliance interior drier. What it does:

• Directs water away from electronics, insulation, and cabinet areas
• Helps prevent drip-related staining and corrosion of nearby parts
• Reduces risk of water pooling that can cause odors or mold
• Fits into the appliance where original shield was installed to restore correct water flow

• One drip shield as shown

• Turn off and unplug the appliance before starting any repair
• Remove panels or components only as needed to access the original shield; keep fasteners organized
• Compare the new part to the old part for orientation before installing