Gth18gcerww Parts

Replace cracked or broken control panel housing for your refrigerator. This protective cover installs over the electronic control area to secure components.

Replacement ice maker cover cap for your refrigerator. Installs over the ice maker assembly. Order a new cap if yours is cracked, broken, or missing.

Fix a warm fridge or freezer ice buildup. This defrost heater melts frost on evaporator coils to restore cooling. Moderate DIY repair, 1-2 hours.

Channels cold air from the evaporator fan through the freezer compartment. Replace if cracked, broken, or missing to restore proper airflow seal.

This plug button is a small snap-in cap used on refrigerators to cover exposed holes on door handles, liners, or trim. It restores a clean, finished look while helping keep dust and moisture out of the cabinet.

• Snaps into a screw or access hole on a handle, liner, or trim panel
• Covers fasteners and gaps for a clean, finished appearance
• Helps block dirt and moisture from open holes
• Typical symptoms: missing cap, broken or loose plug, visible screw hole or cosmetic gap

• Unplug the appliance before servicing and use caution around sharp edges
• Align the plug with the hole and press straight in by hand until fully seated and flush
• For handle screw holes, tighten fasteners first, then install the cap
• Avoid using metal tools on finished surfaces to prevent scratches

Fixes uneven cooling or frost buildup caused by a misaligned defrost heater. This holder assembly secures the element in place. 15-minute repair.

Size: 10-16 ab.

Secures trim and panels in your refrigerator. Replace when broken clips cause loose parts or rattling. Verify fit with your model number.

This holder element assembly secures the appliance's heating element in the correct position so the element stays stable for consistent operation and safe performance. It's a direct-fit replacement for worn or damaged holders. What it does:

• Secures and supports the heating element inside the appliance to maintain proper alignment
• Prevents element sagging or contact with other components that can cause noise or arcing
• Helps reduce vibration and movement that can lead to intermittent heating
• Common symptom: visible holder damage, loose or shifted element, unusual noise during operation

• Disconnect power (unplug or switch off breaker) before starting any repair
• Allow appliance and element to fully cool before handling
• Handle the element and holder carefully to avoid bending or damaging the element

Secures the refrigerator door to the cabinet and provides a pivot point for smooth operation. Replace if cracked, worn, or causing misalignment.

Plastic clip for bottom-mount refrigerators. Secures shelves, bins, or interior components. Replace if broken, cracked, or missing to restore stability.

White plastic corner cap that snaps onto refrigerator door corners to conceal fasteners and protect hinge areas. Replace if cracked, broken, or missing.

The axle assembly that supports the front wheels of your refrigerator, allowing it to roll smoothly during movement. Replace if the refrigerator is difficult to move, wheels wobble or fall off, or the unit sits unevenly.

Secures trim panels and wire harnesses in your top-mount refrigerator to prevent noise and component wear. Replace if loose, cracked, or missing.

Replace cracked or broken door corner epaulets on your refrigerator. This decorative trim piece installs at the corner of the door to provide a finished look.

Bottom door hinge bracket for your refrigerator. Installs at the lower door position to support proper alignment. Replace if bent, cracked, or broken.