Hds255c/01 Parts

Replace a cracked or warped burner cap causing uneven flames or yellow flames on your gas range. This cap covers the burner head for proper heat distribution.

Oven won't heat or reach proper temperature? This heating element restores heat generation. DIY repair takes about 30 minutes with basic tools.

Secures your range door and allows smooth pivoting for proper alignment and seal. Replace if your door won't close fully, sags, or doesn't seat correctly.

The range door hinge plate is the metal bracket that anchors your oven door to the range frame and controls how the door opens and closes. It supports the full weight of the door and keeps it properly aligned. Replace this part if your oven door sags, won't stay open at a set angle, closes unevenly, or feels loose on one side.

This is a temperature sensor used in microwave ovens to monitor internal cooking temperatures. It sends temperature readings to the control board, allowing the appliance to regulate heating accurately. Replace this sensor if the microwave overheats, shuts off prematurely, displays error codes related to temperature, or fails to cook food to the correct temperature.

Secures internal components and panels to restore proper alignment in your range. Replace when bracket is broken, cracked, or missing to fix loose parts.

This insulating part provides electrical and thermal isolation for internal appliance components, helping prevent shorting and reducing heat transfer where wiring or terminals meet sensitive parts. Use it to restore safe operation after damage or wear. What it does:

• Provides electrical insulation for terminals, connectors, or wiring to prevent shorts and arcing
• Reduces heat transfer between hot components and nearby wiring or plastic parts
• Helps maintain safe clearances and protects against chafing or contact-related failures
• Commonly replaced when cracked, melted, burned, or otherwise compromised

• One insulating part

• Always disconnect power (unplug appliance or switch off breaker) before servicing
• Verify correct orientation and seating; do not force the part into place
• Inspect surrounding wiring and terminals; replace any damaged connectors or wires

This is the front facia panel that mounts on the range and houses or surrounds the control knobs and displays. It provides a finished appearance to the control area and helps protect the internal wiring and components behind it. Replace this panel if it is cracked, warped, discolored from heat damage, or if mounting points are broken.

This is a wire rack designed to fit inside the oven cavity, providing a flat surface for holding cookware and bakeware during cooking. It slides in and out on the oven's internal support rails. Replace this rack if it is warped, rusted, or if the wire grid is bent or broken, preventing stable placement of dishes.

This rail guides and supports oven racks as they slide in and out of your range. Replace if bent, cracked, or missing to restore smooth rack operation.

This inner door is the dishwasher's inner panel that supports the door assembly and helps contain water and steam during cycles, restoring a secure, finished door surface. It replaces damaged or corroded inner door panels to improve sealing and appearance. What it does:

• Serves as the interior face of the dishwasher door and provides structural support for inner components
• Helps maintain a watertight seal and prevents leaks from the door area
• Replaces dented, cracked, or corroded inner panels that can trap moisture or cause cosmetic damage
• Restores proper alignment so the door closes and latches correctly

• 1 inner door panel

• Disconnect power and water supply before starting any repair
• Handle panel edges carefully; use gloves to avoid cuts and protect finish
• Installation typically requires removing the outer door panel and disconnecting inner fasteners—keep hardware organized for reassembly