Jms08g0vi Parts

Some parts shown may not be for your model. To see parts for your model only, select it from "Matching Model Numbers" list on the left.

Genuine Ge part

Burner Block Bracket

5.0 (1)

By: Ge

Part Number: WB1K5128

Do-It-Yourself Stories from Customers like You Maintop wire harness had burned / broken connector James T. • Altus , OK • September 20, 2014

Replaced harness and burner block brackets. With the help of photos from appliancepartspro ensurred I had the corret harness, took about 30 minutes, very easy to do. Read more

Genuine Ge part

Screw

By: Ge

Part Number: WB1X1176

Genuine Ge part

Screw

By: Ge

Part Number: WB1X1328

Genuine Ge part

Switch, Oven Small

5.0 (2)

By: Ge

Part Number: WB22X5134

Do-It-Yourself Stories from Customers like You Shaft of selector switch broke off on 1970's era ge wall mount oven Mark G. • Greensboro , NC • November 14, 2015

Turned power to oven off at breaker box. Opened oven door. Unscrewed 3 Phillips-head screws on chrome trim around control panel. Unscrewed 2 Phillips-head screws holding selector switch. Laid control panel down on top of closed oven door. Removed wires by hand from old switch and connected them to the same terminals on the new switch (the wire connectors pull off easily). Using pliers, snapped off all but the lowest segment of shaft on replacement switch. Put shaft through hole in control... Read more

Genuine Ge part

Limit Switch

By: Ge

Part Number: WB24K5029

Lower back

Genuine Ge part

Oven Light Cup

By: Ge

Part Number: WB2X7693

Genuine Ge part

Clip

By: Ge

Part Number: WB2X9105

Genuine Ge part

Door Seal

4.8 (4)

By: Ge

Part Number: WB32K5050

Do-It-Yourself Stories from Customers like You The door seal was brittle and cracked so the oven leaked hot air Carol F. • Martell , NE • November 07, 2014

First, the reader should know that the oven is a GE wall oven, model JKS05P1 and it was 22 years old when I made the repair. I bought the door seal from Appliance Parts Pros so used the directions in the Q&A for this part. I loosened the screws as directed, but the old seal wouldn't budge. I searched online for other directions and discovered the screws needed to come out and the inner-liner needed to be pulled forward just a bit. This relieved pressure on the old seal and it was then easy... Read more