Jvm1870 Parts

• Tray won't turn

This was the first time I had ordered parts from your site but it was relatively easy. The part arrived the day after I ordered and I simply installed it in two seconds, By using your site my microwave was running perfectly in one day. I saved a lot of time and money by not having to call a repairman. Thank you for the great service. Read more

Above the stove microwave took cover off microwave and checked all 4 thermals for continuity and they all passed put in new circuit board and the microwave was still dead went back to the thermals again and found cavity thermal had a blackened connector cut ends off wires and put together with wire nut and microwave worked put new connectors on wires and hooked up thermal tried microwave and it was dead thermal read continuity was good but thermal was bad replace with new thermal and wire... Read more

Plugged it in Read more

The hubby removed vent and the bar that it all attaches to and replaced new bar ,new springs and assemble back together . The vent cover attaches to this assembly and screwed it back. It works like a charm. Read more

I had to remove the microwave from the range and then remove the cover from the microwave to determine the exact problem. After a visual inspection then discharging the high voltage capacitor, I used a meter to test the high voltage diode and fuses. After using the meter to ohm out the magnetron, I removed it from the unit, and seeing that the hole in the end of the magnetron's tube was enlarged and burnt, as if it was arcing, I assumed it was the bad part. I ordered the parts from Appliance... Read more

Dropped unit about six inches by support bolts (cabinet access) and replaced socket light assembly, replaced stovetop bulbs, replaced motorized vent grill. Replaced interior light bulb. I think it defies common sense but you have to drop the unit from its moorings to replace the interior bulb. Owner's manual says it is a two-man job, which compounds this engineering debacle. Actually you can lower it rather than completely deinstall. I had also not been able to replace the stovetop bulbs,... Read more

Follow the trio ubshooting flow chart inside of the microwave panel - and read articles on this website. Turned out to be a thermostat that had popped and gone bad. Replace the thermostat and it is good to go. Read more

Ordered door switches, but didn't solve problem. Sent them back for credit. Ordered thermostat and it solved the problem. Microwave now works fine. The unit is only 7 years old and hope to get another 7 or more out of it. Thanks. Read more

After tracking the source of a prominent noise to the vent motor I removed it and found a replacement part to install. It went very well, and the new motor works noiselessly. Read more

I ordered a new one and replaced the damaged parts Read more