Kbf042ftx03 Parts

Replacement ring for refrigerator assembly. Install this component when the original is cracked, broken, or missing to restore proper fit and function.

Secure mounting clip for refrigerator interior components. Replaces broken, cracked, or missing clips that hold shelves, drawers, or panels in place.

Fix a refrigerator not cooling properly with a new evaporator coil. This part absorbs heat to keep food cold. Moderate DIY repair for bottom-mount units.

Replace your refrigerator's mat if it's cracked, worn, or missing. This mat installs inside your appliance to protect surfaces and reduce vibration.

This bracket serves as a door stop that limits how far the refrigerator door can swing open, preventing it from hitting walls or adjacent cabinets. It mounts to the refrigerator frame or door hinge area and absorbs the impact when the door reaches its fully open position. Replace this bracket if it is bent, broken, or missing, which can allow the door to overextend and cause damage to the door, hinges, or surrounding surfaces.

This is a protective housing that encloses the electronic control board in a refrigerator. It shields the control board from moisture, dust, and physical damage while keeping wiring connections secure. Replace this housing if it is cracked, warped, or broken, as a damaged housing can leave sensitive electronics exposed and lead to control board failure.

36-inch drip tray for refrigerators. Collects water and condensation beneath the appliance. Replace if cracked, warped, or missing to prevent leaks.

Fix a refrigerator that's not cooling properly with a new evaporator coil. This part helps maintain proper temperature in both fresh food and freezer.

This insul-sound deadening pad reduces vibration and noise by dampening panels and components in laundry and kitchen appliances. It's a small adhesive-backed sound/isolation pad used where noise or rattles transfer through metal surfaces. What it does

• Dampens rattles and reduces structure-borne noise from panels, cabinets and housings.
• Helps isolate vibrating components from appliance chassis to lower perceived sound.
• Commonly applied behind control panels, cabinet walls or on motor mounts to cut vibration transmission.
• Useful when worn, detached or hardened factory pads allow increased noise.

• One insul-sound deadening pad

• Disconnect power before servicing an appliance to avoid shock or injury.
• Clean and dry mounting surface; press pad firmly to ensure adhesive contact.
• Replace only in the original location; do not cover vents or moving parts.
• If adhesive is weak, use OEM-approved adhesive; avoid solvents that may damage finishes.

Lower evaporator insulation for bottom-mount refrigerators. Installs around the evaporator coil. Replace if cracked, torn, or missing for proper temperature.

Plastic evaporator cover for refrigerators. Installs over the evaporator coil in the freezer section. Replace if cracked, broken, or missing.

Stainless steel 8-32 x .500 mounting screw for refrigerators and appliances. Replace missing, stripped, or damaged hardware during repairs or reassembly.

Back cover panel for bottom-mount refrigerators. Replaces cracked, broken, or missing rear cover. Installs on the back exterior of the unit.