Kbs5 Parts

Replacement mounting ring that secures and centers refrigerator components on shafts or housings. Needed when original ring is worn, cracked, or missing.

Replace your refrigerator's exterior door handle. Installs on the front of the door for opening and closing. Needed when original is cracked or broken.

This insul-sound deadening pad reduces vibration and noise by dampening panels and components in laundry and kitchen appliances. It's a small adhesive-backed sound/isolation pad used where noise or rattles transfer through metal surfaces. What it does

• Dampens rattles and reduces structure-borne noise from panels, cabinets and housings.
• Helps isolate vibrating components from appliance chassis to lower perceived sound.
• Commonly applied behind control panels, cabinet walls or on motor mounts to cut vibration transmission.
• Useful when worn, detached or hardened factory pads allow increased noise.

• One insul-sound deadening pad

• Disconnect power before servicing an appliance to avoid shock or injury.
• Clean and dry mounting surface; press pad firmly to ensure adhesive contact.
• Replace only in the original location; do not cover vents or moving parts.
• If adhesive is weak, use OEM-approved adhesive; avoid solvents that may damage finishes.

This evaporator fan motor circulates cold air across the evaporator coil to maintain even cooling and proper frost control in the freezer compartment. Replacing a failing motor restores airflow for consistent temperatures and efficient cooling. What it does:

• Spins the evaporator fan blade to move cold air through the evaporator and freezer compartments
• Helps prevent frost buildup by ensuring proper airflow over the evaporator coil
• Commonly needed when the freezer is cold at the evaporator but warm in the compartment, or when you hear a humming, grinding, or no-noise condition from the fan area
• Supports proper defrost performance by maintaining air circulation during cooling cycles

• One evaporator fan motor

• Disconnect power before service to avoid electrical shock
• Access typically requires removing freezer panels or evaporator cover; retain fasteners and note wire routing
• Verify connector orientation and secure wiring; test motor operation before reassembling panels
• If the fan blade is damaged or obstructed, replace the blade or remove the obstruction to prevent repeat failure

This is a defrost heater assembly approximately 48 inches in length that mounts along the evaporator coils inside the refrigerator or freezer compartment. It generates heat during the defrost cycle to melt frost buildup on the evaporator, allowing the appliance to cool efficiently. Replace this part if your refrigerator is not cooling properly, frost is accumulating excessively on the back wall of the freezer, or the defrost cycle is not completing.

Seals your refrigerator utility bin to contain contents and prevent moisture transfer and odors. Replace if bin feels loose or leaks occur. Confirm fit with your model number before ordering.

Rear support base bracket for refrigerators. Secures base components at the back of the unit. Replace if cracked, broken, or missing for stability.

Replace your refrigerator door hinge if it's cracked, broken, or causing the door to sag. This hinge mounts the door to the cabinet for smooth operation.

Refrigerator air duct that directs cold air throughout the fresh food compartment. Replace if cracked, broken, or missing to restore proper airflow.

This insulation bag fits inside the refrigerator or freezer door panel to help maintain consistent internal temperatures. It acts as a thermal barrier that prevents warm outside air from affecting the sealed compartment. Replace it if you notice condensation forming on the door interior, inconsistent temperatures, or if the existing insulation is torn, compressed, or missing.

Replacement screw secures panels, brackets, and components inside your refrigerator. Needed when original fastener is stripped, missing, or lost.

Wire shelf for side-by-side refrigerators. Provides ventilated storage surface for food and beverages. Replace if cracked, bent, or missing.