Need Help?
Call
Some parts shown may not be for your model. To see parts for your model only, select it from "Matching Model Numbers" list on the left.
Replacement support mounting bracket for stand mixers. Holds and stabilizes internal components. Needed when original is cracked, broken, or missing.
If your mixer won't spin or makes grinding noises, the planetary gear assembly may be worn. This part transfers motor power to attachments. Moderate DIY.
This is a small lever that is part of the door latch assembly on a dishwasher, helping to secure the door in the closed position during operation. It engages with the door latch mechanism to ensure a proper seal and signal the control board that the door is fully latched. Replace this lever if the dishwasher door won't stay closed, the unit won't start because it doesn't detect a latched door, or the latch mechanism feels loose or broken.
Solid tilt pin gently pressed into its home and all good. pressed in super easy. only concern i would have for long term is no locking clips or anything so if one were to push on the pin it will continue going thru and fall out again. Reasonably tight compression holding it in now but if i can put in in with one finger pushing, i can also push it out with one finger Read more
Fix a stand mixer head that won't stay locked or tilts during mixing with this head lock assembly. Simple repair restores secure mixing operation.
Fix excessive vibration or unusual motor noise with this stand mixer motor housing. Secures and aligns the motor for stable, quiet operation.
Cabinet base panel that mounts under your stand mixer to protect internal components and stabilize the unit. Replace if cracked, broken, or missing.
This Trim Band is the outer-facing trim piece that restores the finished edge and appearance of the appliance door or opening. It replaces bent, cracked, or missing trim to help the appliance look and seal properly. What it does:
If your stand mixer bowl lift won't stay up or slips out of position, this spring roll pin secures the lift arm linkage. Requires pin punch to install.
I followed the online tutorials, there are many....replaced the PLASTIC part that had worn out Part #: AP4325266 (241764), and also the roll pin, Part #: AP3038054 (9703442) that held it in place with the handle. THIS IS THE HARDEST part of the entire repair, pounding out the roll pin and pounding it back in. A special tool should probably be used for this. I had a small specialized driver bit that "fit" for the job, so I abused it. Probably didn't need to BUY a NEW roll pin, ( it HAS be... Read more
Usually ships within 4 - 14 days
If your mixer runs intermittently or loses power, a cracked or missing brush holder cap may be letting the carbon brush slip. Simple threaded repair.
If your mixer speed won't stay set or the lever is cracked, this speed control lever restores precise speed selection. Simple DIY fix in minutes.
Secures hinge, lever, or linkage to its bracket on your stand mixer. Replace this screw if stripped, missing, or damaged to restore proper alignment.
By continuing to use our site, you agree to our Terms of Usage and Privacy Policy. You can learn more about how we use cookies by reviewing our Privacy Policy.
We use cookies to optimize website functionality, analyze the performance, and provide personalized experience to you. Use the controls below to manage your privacy preferences.
Cross-Site Advertising
When enabled, we may use cookies and similar technologies to deliver personalized advertisements based on your browsing activity across different websites. Opting out will disable third-party advertising cookies on this site.
Analytics Sharing
When enabled, we may share anonymized browsing and usage data with third-party analytics providers to help us understand how visitors use our site. Opting out will prevent this data from being shared with third parties.