Kenmore 73433 Parts

This spin speed knob lets you select wash spin settings so you can adjust water extraction for different loads. It replaces a worn, cracked, or loose dial to restore clear speed selection and smooth control. What it does:

• Selects the washer's spin speed setting for proper water extraction
• Restores firm, accurate dial operation when original knob is loose or broken
• Helps prevent accidental speed changes during a cycle
• Matches OEM fit and detent locations for correct alignment

• Remove power from the appliance before attempting replacement
• Typically pulls off the control shaft; inspect for retaining clip or set screw
• If knob does not seat fully, verify shaft and index tab are undamaged

A single replacement screw fastener used to secure trim, panels, or internal components. Fits specific Frigidaire appliance locations to restore proper fastening and alignment where factory hardware is missing or damaged. What it does:

• Secures plastic trim, brackets, or metal panels in refrigerators and freezers
• Restores proper alignment and prevents rattling or loose parts
• Replaces stripped, corroded, or lost hardware to maintain appliance function
• Works wherever the original factory screw was specified

• One replacement screw

• Use the correct screwdriver or bit to avoid damaging the screw head
• Do not overtighten; snug until seated to prevent cracking plastic or stripping threads
• Replace only with the exact factory part for proper fit and function
• Unplug the appliance or turn off power first if working near electrical components

This steam vent linkage is the mechanical connector that operates the appliance's steam vent, allowing controlled release of steam during cycles to prevent excess pressure and moisture buildup. Replaces a worn or broken actuator linkage to restore vent movement. What it does

• Transfers motion from the vent actuator to the steam vent so the vent can open and close properly.
• Helps release built-up steam during specified cycles to reduce excess moisture.
• Commonly replaced when the vent is stuck, does not move, or makes noise during operation.
• Supports normal vent sequencing—does not include electronic actuator or motor.

• One steam vent linkage

• Disconnect power (and gas if applicable) before beginning any repairs.
• Moderate disassembly of the cabinet or control area may be required; keep fasteners organized.
• Inspect surrounding components (springs, clips, actuator) for wear and replace if needed.