Kenmore He2t Parts

Rubber grommet for washers. Installs to cushion components, seal openings, or protect wiring. Replace if cracked, torn, worn, or missing.

If your washer won't agitate or spin, the drive motor may have failed. This motor powers the drum movement for washing and spinning cycles.

Fix F01 error codes, cycle failures, or spin issues with this washer electronic control board. Restores proper cycle timing and function control.

This seal creates a tight barrier between mating surfaces in your appliance, helping contain heat, air, or moisture as intended. Replacing a worn seal helps maintain performance and reduces the chance of leaks, drafts, or condensation at the joint.

• Provides a tight gasket between designated components
• Helps prevent leaks, drafts, or heat/steam escaping for proper operation and efficiency
• Restores fit when the original seal is torn, compressed, brittle, or missing
• Common symptoms include poor sealing, condensation or residue around the joint, or visible wear/damage to the old seal

• Disconnect power; shut off water or gas before servicing
• Note seal routing/orientation and remove the old seal; clean mating surfaces of debris/adhesive
• Install the new seal evenly without stretching or twisting unless OEM instructions specify
• Reassemble and check for proper closure and operation; inspect for leaks or gaps

This clamp secures a flexible appliance hose to a fitting to help prevent leaks and keep connections tight. It's a small but essential part that restores a proper seal on water or drain lines. What it does:

• Holds a hose firmly to a tailpiece, barb or connector to reduce leaks and hose slippage
• Helps stop intermittent dripping or pooling caused by loose hose connections
• Restores a proper seal after hose replacement or maintenance
• Works on common appliance water/drain lines where this clamp style is used

• One hose clamp

• Disconnect power and shut off water to the appliance before starting any work
• Allow the appliance and hoses to cool if recently used; use gloves and eye protection
• Use appropriate pliers or a screwdriver (depending on clamp style) to remove and install the clamp; avoid over-tightening
• Inspect the hose and fitting for damage; replace the hose if cracked or worn

Mounting screw for washer assembly. Secures components and panels in place. Replace if screw is stripped, missing, or no longer holds parts firmly.

Replacement door handle for washer exterior. Restores secure grip and proper door opening when original is cracked, broken, or loose. Direct fit replacement.

Panel mounting screw for laundry centers. Secures control panels, trim pieces, and access panels. Replace missing, stripped, or damaged screws.