Kfrc302epa00 Parts

Small flat washer for KitchenAid stand mixers. Installs between mechanical components to ensure proper spacing. Replace if worn, cracked, or missing.

Replace a damaged or frayed wire harness in your grill. This electrical wiring assembly connects internal components and may need replacement if cracked or worn.

Is your grill flame too low or won't stay lit? This gas regulator controls propane flow to maintain consistent heat. Typically installs in under 30 minutes.

Wire harness for grills. Connects electrical components to control panel. Replace if wires are frayed, connectors damaged, or harness is missing.

Fix grill ignition problems or control panel failures with this wire harness. Restores electrical connections for reliable operation. Simple repair.

Grill won't ignite or heat properly? The main gas valve controls gas flow to burners. Moderate DIY repair with basic tools. Fits multiple models.

Fix a grill that won't power on or trips repeatedly with a new circuit breaker. This safety component protects electrical circuits from overload.

Fix a grill that won't light with this surface ignitor replacement. Solves clicking without ignition or burners that fail to start. Standard DIY repair.

Fix uneven cooling or freezing coils with this air conditioner capillary tube. Controls refrigerant flow between condenser and evaporator coils.

This main water inlet valve controls washer water flow, allowing the machine to fill and switch between hot and cold as needed. Replacing a worn valve restores reliable filling and helps stop unwanted leaks or continuous filling. What it does:

• Opens and closes to route hot and cold water into the tub during fill cycles.
• Directly affects fill timing and water temperature selection.
• Fails can cause no-fill, slow fill, continuous fill, or leaking at the valve connection.
• Works with the washer's control signals and internal hoses to manage water delivery.

• Disconnect power and shut off house water supply before starting; relieve water pressure by running a drain cycle or opening a nearby faucet.
• Verify correct hose and connector orientation during installation; tighten fittings to OEM torque—do not overtighten.
• Inspect inlet hoses and seals; replace any damaged hoses or O-rings to prevent leaks.

Fix uneven heating or burners that won't light with this grill gas valve. Controls gas flow to burners. Moderate DIY repair with basic hand tools.

12-pack mounting screws for various appliances. Replaces missing, stripped, or damaged screws used to secure panels, brackets, and components.