Khwso1pmt2 Parts

This replacement base is the lower cabinet support that secures the appliance frame and helps keep the unit stable during operation. Restores proper alignment and support for the cabinet and internal components. What it does:

• Supports the appliance cabinet and keeps the cabinet aligned with the chassis
• Helps reduce cabinet sag, excessive movement, and rubbing against the floor
• Can resolve vibration, rocking, or uneven operation caused by a damaged base
• Provides the mounting surface for other lower-frame components

• Disconnect power (and gas if applicable) before starting any repair
• Use basic hand tools to remove and reinstall mounting fasteners; keep hardware organized
• If any clips, gaskets, or fasteners are damaged, replace them to ensure a secure fit

Protective cap cover for washer exterior. Replace if cracked, broken, or missing. Restores clean appearance and protects internal components.

Inconsistent or improper dispensing of detergent, fabric softener, or bleach This OEM Whirlpool part is also compatible with Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper, and Kenmore models.

This is a leveling foot for a washing machine. A leveling foot is located at the bottom of the washing machine and can be adjusted so that the washing machine sits level on the floor, even if the floor itself is not level. There is one leveling foot included in this pack. A new leveling foot may be needed if the original is broken or stripped. If it won't hold a position, then the leveling foot will need to be replaced. These are very simple to replace, with the exception of needing to reach underneath the unit. These screw into the bottom of the washing machine. Never perform care and maintenance on an appliance that is powered on.This is a genuine Whirlpool part and is sourced directly from the manufacturer. It is sold individually. This specific leveling foot is compatible with washing machines manufactured by Whirlpool, KitchenAid, and Maytag.

This drawer hook is the retainer that keeps an appliance drawer securely seated while still allowing easy release for cleaning or service. Replacing a worn or broken hook restores smooth, reliable drawer operation.

• Secures the drawer in its housing so it stays closed during use
• Acts as the catch/release point for removing the drawer when needed
• Helps maintain proper alignment for smooth opening and closing
• Common symptoms: drawer won't stay closed, pops open or falls out, won't latch, or the hook is visibly cracked/missing

• Disconnect power before servicing
• Fully open and remove the drawer to access the hook area
• Align the new hook with the slots/tabs and snap or seat it into place
• Avoid forcing components; refer to the service manual for model-specific steps

Fastener screw

This small retaining fastener locks an assembly, bracket, or panel in place inside your appliance. Replacing a damaged or missing clip helps stop rattles, keep parts aligned, and restore a secure fit.

• Secures a panel, bracket, trim piece, or harness to the appliance frame
• Helps prevent shifting and vibration during operation
• Common symptoms: loose or misaligned parts, rattling noises, or a clip that is cracked, bent, or missing
• Restores proper retention after service or when the original fastener wears out

What's included: 1 clip Install notes:

• Disconnect power before service; for water-using appliances, also shut off the water supply
• Note the original clip's orientation; take a photo before removal
• Use needle-nose pliers or a small flat screwdriver; avoid over-bending the clip
• Replace any additional damaged clips to ensure even retention